Activity Stream

1.26 volts has been solved, but how to keep the 8.1L motor running is the next concern. I can rev with the throttle blade to keep it going but...

Hi there, I'm S?ren from west germany. I'm owning a new (2023 model year) Challenger R/T I want to do some basic changes to. I already did some...

i would like to see the V10 Excursion file if you have it.

What you are doing is trying to run a 06 4L80 vehicle with a 05 4L60 calibration. That doesn't work. Changing that switch to 4L80 doesn't make it a...

i would like to get my hands on both files, i want to help my friend tune his v10 excursion and be prepared in advanced for what changes i can make...

yes i see a lot more now so im just a glorified parts changer at most trying to step up the motor i put in my truck came out of a 99 silverado with a...

I think what 2xLS means is basic/small changes in the VCM Suite you (write) which generally it won't write, if doing more major changes like Tranny...

i just set my tuning to advanced however im not sure what to really do like i said i am new to this and right now my truck is throwing a p0740 and...

Here's a stock file if you still need it.

Why wouldn't you be able to change the ECM to a '09-compatible service number and use a manual trans '09 LSA CTS-V OS? I could be wrong but I don't...

Cam sensor fault did not default to low octane on my 4x L31. Only a MAF or Knock sensor failure does that.

Cam, long tubes, 42# injectors 25348180, vacuum referenced rails. It did it with the stock 5.3 injectors as well.

I don't know what you mean by reflashed it but the file you posted isl a 05 5.3L 4L60 calibration that will not be compatible with 06 ETC hardware....

Thanks bro, i made the suggested changes. Took for a test drive. it didn't happen yet, so i'm hoping this was the fix!! I appreciate it.

That doesn't magically make it a 4L80 calibration.

https://ls1tech.com/forums/conversions-swaps/1588653-88-fiero-formula-ls4-f40-6-speed-swap.html Is this the build in question?

Are you on (Basic) or (Advanced) mode? That might be why. Go to (Edit) Then (View) to check.

You would be much better off changing to a manual trans ECM OS and ditching the TCM. Manual trans ECMs have all the things (like VSS) wired direct to...

I had the same issue originally. Go to engine -> torque model -> friction loss tables: zero out the bottom right cells for 100kpa for 3200rpm to...

Where would I go to look for and do this at? Are you referring to when running the scan tool? NM, I see what you are saying in scanner part.

Noah, just emailed you an update. Pedal Mapping and Final Fueling (Main Pulsewidth Table) still need to be finalized, but this should get the...

it doesnt show me that option

:) Yes the F40 is a 6 speed manual transmission. I already started taking out the faults being reported for the auto no longer being there. Because...

The file you put up shows (4L60} Try switching to 4L80. Its under Transmission=General.

Minor detail considering the other issues, but you need to remove all of the bank 2 fuel trims & O2s from your channels list, that engine is treated...

Sorry for the late reply my ecm went out on the truck i was working on i found another p59 ecm however its out of a 2005 gmc sierra i hooked it up...

OK, I am officially well beyond confused right now. The F40 is a six speed? And your log file shows 'T42, GM A4'. I've either badly misunderstood...

You also have a bunch of pending & current TCM codes you need to sort through.