Activity Stream

Injector offset vs ignv is in seconds according to what I'm looking at. Right click go to units and it is set on seconds (s).

Do what 5f mentioned, it will work!!

If the fuel injectors are properly calibrated to what they actually are, and MAF is dialed in, engine tq should be close... If you are at -50 tq...

https://www.ausinjector.com/56010-750-8-d/

The difference between 0.00 and 0.50 in the world of torque converters probably will not matter unless you are on the throttle from a dead. Even then...

Been here! I did tune a swap that started as a E38 2008 Corvette with a manual transmission. That was then paired with a T42/4l65e. Now I...

Try adjusting your Torque correction in Engine Diagnostics I'm thinking you may have to much in airflow max rpm try there and also P2173 Add adapt...

.15 is about the fastest it could possibly achieve, so going above will only force the ecm in to max adapt. ive used .15 without incident. command...

I was able to get a pull in making 738hp over the previous 677hp with bigger pulley and stock manifolds. I thought I was good to go. I unstrapped...

appears Julio has replied to all of your tickets, if you are still in need of assistance I would recommend communicating this via the ticket 254750 ...

I have a '96. If you don't get help from anyone else let me know and I'll see if I can get a read for you.

Looks like you entered voltage offset values in micro seconds, but with the unit set to milliseconds. This makes the ECU open the injectors far...

Ok, So to answer the question, When I try to read the TCM it does give us a message popup that says that the TCM needs the unlock service performed....

Bill, thanks for your response. My initial Ticket # 254750, is followed by other associated ticket #'s: 255658, 256298, and 256679. My last and only...

Here is a 5min idle log after flashing the modified tune you sent. Thank you so much for taking time to help me!

I will get a log to you ASAP. for reference here is a video of a cold start with the dip happening around 80 degrees F on the coolant temperature....

Might be the coil, it does seem like an electrical thing but i dont know.. I did put a physical gauge on the fuel pressure (old school i know) ...

I have tried both ways. The problem is that I seem to lose the GPS data, so lap times, and other things do not show up. I have spent the last week...

Exactly.

Sorry, haven't been here lately until now. Compare against attached tune.

Yes possible..Unfortunately, not with HPT.. I tried it with success using BitBox software.

I also did that i put it as a 2 bar because y have a 2.5 bar map, but on th very right side on the option says under parenthesis (pressure) if I use...

A stock tune is not going to run with a cam, different injectors, etc. Did you use the GTO intake tube, filter and MAF? If not, where did to put...

Scan cylinder misfire and look at Each cylinder (you will have to to add these to the channels)

Try this...