Activity Stream

Scrappy, I just noticed on my old tunes, they run worse after adaptives are reset! The 2017+ pressure presets in my 2012 feel like the offgoing...

Enable shift lock to keep the converter locked, that being said a stock 4L60E will not like that. Beyond that it should lock the TCC in 3rd stock. My...

The missing, im assuming (maybe wrongly) that the missfire shows as KR? So the plugs are okay? Or shuld i change to colder? unsure if thats the...

You have knock retard or it’s missing? Not sure how wires could cause knock. Am I missing something?

This is why I don?t go super crazy with power, it gets to the point where the shit isn?t even fun anymore. Spend more time fixing shit than driving...

760 wheel horsepower. Not crank. But that was on e85 with meth on a borg s476 on 11psi (L83)

Thanks---In process

25-TSP224236-112-3B; Texas Speed & Performance Camshaft: 224/236, .600/.600, 112 LSA 107 I have to work on my acronyms. I'm old enough to still...

This seems to be solved now. Almost all valve springs were broken. I havent disassembled the heads yet but I hope valves and guides are OK. This...

I see those numbers, and that would make sense, as that's about what I'm seeing. Thank you. I don't think I messed with cam angles...at least not on...

Just get a JMS voltage booster. Problem solved. No crazy wiring shenanigans.

Also i can hear it popping and banging in the exhaust, not sure if detonation or just raw fuel in the exhaust....

Im an idiot and did not include a log, sorry.. It comes here: There's nothing done to the engine, totaly stock.. I'll change wires if you say the...

You take ID1000 data and give a try...

You do realize that a 1000 HP LS is literally any junkyard engine, and literally any aftermarket camshaft (with the right cam it would not even need...

check out a stand alone something with a throttle cable maybe?

your blower is pushing compressed air into the cyl (while the intake valve is open) that valve starts to open on the exhaust stroke... it does...

Here?s my final coastdown table I?m happy with. Just enough that?s not too annoying for me. And the rpm range is perfect so that I?ll only hear it in...

Both banks of coils share the same ground (G102), but they do have separate fuses (INJ A, INJ B).

I agree with sirisc1012. I have a c6 corvette and I tried everyone?s recommendations on editing the decal spark tables and that didn?t give what I...

Was this crank HP? I was making 832 RWHP on a mustang Dyno (1,040 crank) in 3rd gear when I was hitting the fuel limit on my previous setup. Was...

During the roll race event I was dialing in the aux pump along with a few other adjustmetns and was able to increase the duty cycle 1 degree each...

This is the last log I did while at the ICC 2024 roll race event in September. Going back and looking at the logs I can see the pressure was...

Heres a good comparison for you, when I installed the cheap Amazon chinese knock off, it was holding quite nicely @ 19psi but I decided to swap it...

I have 14 psi wastegate springs which the stock pump typically handles very well. With the DSX aux pump and the previous Armageddon in tank pump, I...

Correct, I have the DSX aux pump that kicks in once it sees boost. This is the in tank pump I swapped out with the one Armageddon sells. They take...