Activity Stream

Yes. Anything below 100KPA is vacuum

So, if i'm understanding correctly; it depends on whether you're in SD or blended?

i have no idea what several variables are - but the fact that you have a supercharged hemi, have installed larger injectors, and are here asking for...

Shift points and converter lockup do make a big difference as does making them go into PE when the go pedal is mashed over ~50-60% throttle. I shoot...

Come on, you been here long enough I should not have to tell you NOT to log MAF Hz or MAF lb/hr or g/s channels when you want it to be ignoring the...

Also IAC completely shut (or, it thinks it is) yet idle RPM is ~1500.

HP Tuners sorted me out and I wrote the tune to the car half an hour ago. Took it for a run around the block a couple times. Definitely noticing more...

I would wager those readings will be identical if you log with the sensors unplugged entirely, so time to break out the multimeter.

Just PE fuel & maybe some ignition timing if you want to run 93 octane. I usually tune most of these 6.0L tow vehicles to make due on 87 octane....

i'm at almost 7000 ft and its a crew cab if i was boosted 1st might be to sort but for now i don't think second gear leave would help dead hooking i...

Hey, I don't really understand your question but your vehicle is from the global B family so you have to unlock it, it cost 500$ via hptuners. When...

I doubt that cam has less VE at WOT at lower rpm than it did. Certainly by ~2,000 rpm it is moving more airflow. I have tuned a bunch of cams similar...

It would be much better to change that out especially since if you have a converter, or you could leave in 2nd gear like some guys do anyhow with...

3.92

whats a good formula for startup is there a datalog setup you recommend?

What gear do you have in the rear ?

who's 93 are you equating to which race fuel

Correct, however it is possible to add the IAC driver to a "dbw only" p59, but that is a whole different topic.

Okay, I did misspeak. All p59s CAN be drive by wire. Some p59s can be drive by cable.

Just to be clear, NO, not all p59 computers were DBW. Several are cable throttle computers.

Easy fix :-) My car had a nag1 5 speed originally but cruise works in any mode, luckily. You have a different deal going there and sounds like fun.

hahaha i'm that jackwagon messing with it haha i only have normal mode and my truck did not come with the gear limit switch on the cruise control...

yes maf is unplugged and exhaust is unbolted at the cats because i was thinking they were clogged due to the weird o2 readings i was seeing but it...

OP's 04 pedal and tac module is fine for his swap. He has a 04 pcm which works any 03-06 dbw throttle body.

I will go over the shifting again a little better, In a typical hellcat, or my HP 70 car there are 3 drive modes to choose from. Track mode in those...

https://www.pcmofnc.com/product/pcm-of-nc-4l60-70-to-4l80-conversion-harness/

I don't think GM ever made a 4L80 calibration for this particular operating system. This gets discussed every few months...