Activity Stream - HP Tuners Bulletin Board

Sort By	Time	Show
Recent Recent Popular Popular	Anytime Anytime Last 7 Days Last 7 Days Last 30 Days Last 30 Days	All All Photos Photos Forum Forums

3 Minutes Ago

Chadmoore88s@Yahoo.com replied to a thread 2007 pontiac grand prix 3.8 vats delete help in GM V6 Tuning - Miscellaneous

It would run and stall quickly

11 replies | 369 view(s)

4 Minutes Ago

Chadmoore88s@Yahoo.com replied to a thread 2007 pontiac grand prix 3.8 vats delete help in GM V6 Tuning - Miscellaneous

No, when i tried flashing with vats selected to off, it would turn over actually, but would either run really badly(limp mode/no fans etc) or not...

11 replies | 369 view(s)

36 Minutes Ago

Larry Reed replied to a thread E38 idle tuning in GM V8 Tuning - Engine, Gas (Gen 4)

Yes sir, that is correct. I have MAF running fairly well but can't run SD at all because it is so rich.

6 replies | 167 view(s)

1 Hour Ago

kangsta replied to a thread Where is the 'Marker' function? in VCM Scanner

+1 ! I was logging the other day and went scouring through the helpfile to find what the key was. Cant believe its not a feature, spacebar should...

28 replies | 5723 view(s)

2 Hours Ago

Ieniurim replied to a thread turning reversed and brake and acceleration reversed? in RaceRender

Did you know what it is for VIN-code? VIN-code is a reliable and unambiguous identification of the car, practically not amenable to falsification....

4 replies | 657 view(s)

4 Hours Ago

pontisteve replied to a thread 2007 pontiac grand prix 3.8 vats delete help in GM V6 Tuning - Miscellaneous

Did you get your car to run? If not, I can delete VATS for you.

11 replies | 369 view(s)

5 Hours Ago

Matt_lq4 started a thread ZF8HP 8 speed tcc lockup settings (14' Ram) in Dodge Tuning - Transmission

For the torque converter lockup in 6th gear, are there any ill effects in adjusting the "6: slip --> lock" values (2300 rpm in the table) down...

0 replies | 21 view(s)

5 Hours Ago

jm8126 replied to a thread Help!!! u0107 code DBW issue that has me stumped in GM V8 Tuning - Engine, Gas (Gen 3)

How do I do that? I have an 06 file. Is it the hard write? I tried doing it but I might be doing something wrong because it says the vin...

4 replies | 98 view(s)

5 Hours Ago

thunderbolt replied to a thread 2008 6L90E with L83 Gen V problems. in GM V8 Tuning - Transmission

I was worried about the programming. Did som more searching at it seems that a 2011+ TEHCM will bolt in so I will try that.

2 replies | 89 view(s)

5 Hours Ago

jrogers0696 replied to a thread 99 cherokee 4.0 crazy knock retard in Dodge Tuning - Engine, Gas

how to you attach documents?

1 replies | 25 view(s)

5 Hours Ago

jrogers0696 started a thread 99 cherokee 4.0 crazy knock retard in Dodge Tuning - Engine, Gas

so im stumped at this point, i have no idea why im getting this knock retard and ive done everything to try and stop it, all spark ive even turned...

1 replies | 25 view(s)

5 Hours Ago

RJSenterprise started a thread Lq4 1500hd safe turbo tune in GM V8 Tuning - Engine, Gas (Gen 3)

Truck is a 1500hd, so right around 5500lbs. Only running 5 psi so far and 4-6 degrees of timing in boost. Afr is rich at 10.2-10.5. Stock everything....

0 replies | 20 view(s)

6 Hours Ago

eisaalali replied to a thread LT4 High side help in GM V8 Tuning - Engine, Gas (Gen 5)

did you change your MAP sensor? , because I have looked onto your log file it shows at KEY ON Engine OFF show 200 KPA on the other side it should...

3 replies | 202 view(s)

6 Hours Ago

metalmanimal replied to a thread 3 MAFs Dead or PCM ? in GM V8 Tuning - Engine, Gas (Gen 3)

I haven't tried to run it in mixed mode yet, give it a try tomorrow. here is my Maf logging and mixed mode tune. Could it be because I have PE...

2 replies | 38 view(s)

6 Hours Ago

Hooch started a thread Timing/O2 Fluctuation Procharged LS2 GTO in GM V8 Tuning - Engine, Gas (Gen 4)

Working on a E40 GTO with a P-1SC Procharger. Car was previously tuned and drives/runs fine and AFR is running where it should be. However, when I...

0 replies | 23 view(s)

7 Hours Ago

fcar1999ta replied to a thread MAF table for LS7 MAF in a 5" housing? in GM V8 Tuning - Engine, Gas (Gen 4)

I don't have the Pro Link connected to the wideband yet, so I will have to eyeball it as much as I safely can.

9 replies | 144 view(s)

7 Hours Ago

StreetBikeSammy replied to a thread Larger injector scaling for smaller injectors in GM V8 Tuning - Engine, Gas (Gen 3)

Right on I changed them to 48.5 @ 60kpa or so. Also changed my injector boundary back to 6.50. Don't know why that was 7.27. I don't usually see...

4 replies | 73 view(s)

7 Hours Ago

5FDP replied to a thread MAF table for LS7 MAF in a 5" housing? in GM V8 Tuning - Engine, Gas (Gen 4)

Obviously closed loop will always come back to stoich, that is what it is suppose to do. See what fueling is like with your wideband under load in...

9 replies | 144 view(s)

7 Hours Ago

blindsquirrel replied to a thread High idle, only in drive?! in GM V8 Tuning - Engine, Gas (Gen 4)

And I double checked, nobody drilled a hole in the throttle blade while I wasn't looking. :p

3 replies | 32 view(s)

7 Hours Ago

blindsquirrel replied to a thread High idle, only in drive?! in GM V8 Tuning - Engine, Gas (Gen 4)

Heh, you noticed the crank-chug-die just from that logfile? That's literally the one and only time it's done that in the two years I've owned it, and...

3 replies | 32 view(s)

7 Hours Ago

kevin87turbot replied to a thread High idle, only in drive?! in GM V8 Tuning - Engine, Gas (Gen 4)

I had this same issue on a P59 application a few months ago. It was very odd. The only way I was able to fix it was to remove airflow from the Min...

3 replies | 32 view(s)

8 Hours Ago

Motorsports-X replied to a thread Can access repo - need Express van file in GM V8 Tuning - Engine, Gas (Gen 3)

That got it! Thanks! I never even knew that was an issue.

10 replies | 127 view(s)