Activity Stream

data log would help,

Looking forward to it. Thanks for the updates!

No changes.

I talked to support , they act like no one has ever submitted a ticket about this issue.

Hey guys! Thanks for all the debug work, it's truly appreciated. I just ran 5.1.4628 beta on my 2025 GT PP, and it hung while I tried to 'Read...

Thanks Guru, I loaded your tune and this is the log.

I am still running same tune, the 2nd one. I think all my questions are there clearly. My statements are assumptions...are they correct?!?!

All you guys asking for Whipple/Roush support. Give me time to get those defined.

If you want to start a new thread vs an existing one, you need to explain what you are working on again. If you have done additional tuning in the 6...

although I am feeling really happy with where I am at....I still think my throttle response when I blip it off idle could be better...but that might...

hi @Sweet35th what is the status now? • Will the MPVI2 (or MPVI3) interface support all PIDs, reflashing, and logging on my Edge’s PCM/TCM? i...

Fuel pump doesn't look like a problem either. They will fall a couple PSI.. much more than this it might can indicate a issue but you need to log...

This doesn't look lean at all. Fuel trims are averaging pretty close to zero. This is closer on fuel trims than most factory off the road cars. ...

You are correct. I thought it only worked with the RTD devices, but that was incorrect.

S650 reading should be working as of VCM Suite 5.1.4626. We've confirmed on three cars at this point, but you may need to retry multiple times before...

I took your tune and put into SD so you can tune the VE. Youre lean in most the areas youre getting knock, as was pointed out. I changed your...

For 24x, only 1x cam is currently supported. For 58x, both 1x and 4x cam work. It is always advised to use a timing light to ensure correct...

Yes From my limited expearience, its more for when you add a booster pump and how that "spike" in pressure/flow is dealt with. Might not be enough...

So to confirm if my new build is 58x trigger and 4x cam gears there is no need for the lingenfelter box correct? This ecu allows you to change to...

fix this

I think sirius had a 98 or 2000. Mine is a 2002 ws6 LS2 swapped, LS3 top end with a TSP F35 cam kit in it and a 6sp. Just got done doing UMI...

If you send me your file I can help you out

This sounds like a stock PCM, if you purchased the crate engine setup from GM there should be no limp mode. Depending on the calibration make sure...

Very possible as there were only ~1,000-1,500 made according to the internet. Part number is 4014453. Says on there that it is programmed for a rzr...