Activity Stream

Those 50lb injectors recommended by blindsquirrel work very well due to their response. Personally, I'd buy new off rockauto. You'd need adapters...

There goes that math stuff again. Funny how a little bit of good data goes a long way. Thanks for that. Yeah, I don't currently plan on doing...

Gotta be careful drilling and tapping thin walls. See the spot up front where the MAP goes? You can put a TMAP (0261230217) in there instead that...

Use the R word again and you won't be here much longer.

Great just what I was wanting. Would you put the sensor in the manifold or in the silicone pipe pre TB. I have a 00 WS6. I don't mind drilling and...

That or calculate. Stock pump is 255l/hr@4bar. To find max injector size that's 255*sg(gasoline)/hr = 186.15kg/hr = 410.39lb/hr. 410.39lb/hr /...

I understand during cranking, but its staying in the 8:1s while warmed up and running?

Not at all, I have seen 3.5-4:1 briefly on stock GM tuned vehicles in 0F weather during cranking.

I see you cracked some other 2024 models. Any news on the Raptor R?

“Will work” and “should be done” are two different things. I know of at least two major tuners who leave the torque tables stock. Should it be done...

Yes.

At that point, a window pops up that says "turn ignition off wait 10 seconds and turn back on." However, lately it's been popping UNDER instead of...

I hadn't really thought about it too much, but it sounds like I may need to look into a fuel pump upgrade with the injectors. Would I confirm this...

19418810 supersedes 12615136. https://www.newgmparts.com/oem-parts/gm-barometric-pressure-sensor-19418810 The values for this are 200/8. Use...

https://aka.ms/dotnet/8.0/windowsdesktop-runtime-win-x64.exe

What I have for an IAT curve is very close to what you came up with.

Welcome.. you'll notice this side is mostly a ghost town now days compared to the GM section. I think there is a thread in the EEC-V section that has...

No problem

map sensor is a 19418810 ac delco. have the iat in the charge pipe after the intercooler. had the offset at 9 kpa but it was reading 106 kpa koeo....

Awesome thank you

Unless you're running very low boost. Absolutely no.

i dont see any underlying issues mechanically. pulling plugs/replacing, checking compression and checking everything else shortly. This is a new...

0kPa for values to the other columns of injector offset. .243 for Min PW like default .243 value. Fuel>Transient>Min Fuel Mg to .008. ...

Check yer messages