Activity Stream

How about the FPR? Before or after the rails?

Yeah you can make it what you want, but put the formula that's the formula found in the manual. Page 10 of the AEM 30-0300 manual gives the...

Yeah it's pretty cool isn't it?

Do a tps relearn. Set Engine>Advance>Base>TPS Hyst. to 0.39 and >Max Speed to 200.

color scheem of the motor says it meant to be

My AEM went bad in about a year. I don't like them, but it's cheaper to keep putting sensors in than to buy a new unit from someone else. Bosch O2...

Looking forward to it, too.

i remember when the lightning came out with a aluminum driveshaft, old school never understood that at the time.

Are you playing a joke? It has the 2bar SDOS applied. Both tables are used. Spark in the log matches the High Octane table...

we ended up using my stock ac delco?s that i had and the issue actually ended up getting worse. we checked all of the wires to ensure that they were...

We did a pull in 2nd gear to run a different test early on and I just noticed the timing appears to be locked in on the High Octane table. Are we...

I hope I live long enough to actually finish getting this thing back together, running and tuned! Icing in the cake would be a successful run from PA...

I’m also relatively interested in personal experiences with such, not just data

You can try this. You may need to compare/change the DTC. If you flash after comparing the two, you have to select flash write entire.

Dude your amazing but I really wanted to carry out the work haha thanks again for saving me the trouble!!!

If any part of your first sentence was true you would already have your answers.

If you plan on doing many cars, especially power adder/methanol, etc. Go with ballenger in a ntk sensor. AEM x-series are fine for light duty use....

I've never once had a problem with the AEM widebands using the 4.2 and 4.9 sensors. They are very accurate for what they are. I can switch either...

Glad you got it fixed, thanks for taking the time to post the fix.

So a Denali has a tire p275/60r20 approx 35 inch diameter using 7th gear should be 3,100 rpm. Sounds exactly what you said RaceReady. I would have to...

Replaced the pcm today and reprogrammed and segment swapped my tune and all is good . Trans shifts great again. Idk what happened or what I did but...

Thank you Russ!

Made the changes with my older version. Russ Kemp

I set up the Torque convertor pressure & lock-up speeds. I don't have the same OS to see if the TC apply ramp is stock, so return the ramp table to...