Activity Stream

Yes you can use the Motec LTC to bring Lambda in over can using the prolink cable on a mpvi3. I am currently doing this. We did have to slow the...

I will take a look this evening and see if its detecting any

tacho output usually needs a pullup voltage so a 10k resister between power and the output pin to give it a voltage should work, if that is what u...

I gotcha. Didn't even look. Might woulda helped if I did LOL. If it's not "scaled" then yeah seems like it has real shallow lungs.

Yes that actually surprised me. Because the factory ones were bigger. I bought this thing with the engine work already done. Who knows

Data is correct for the injectors. Apparently at some point they got changed.

Yea, but mine shows correct timing in the scanner, 22.5 as tested, and this morning i bumped up to 26 and no knock still, mine is a 17+

Which holly intake does he have exactly?

Sounds like it needs more fuel pump.

E38, E40, E67, E92, T42 all have the same round terminals for all locations except the big main ground on the ECMs. T42:

Airflow numbers in the log are off most likely because the injector data is off. The airflow numbers being low may not have anything to do with it...

What scantool(s) are you using?

Yep once you start putting air filters, ribbon deletes, and even adding more rpm (limiter lifting) you should be working on the VE table, in saying...

Ok , yes, got it.Any other mod on intake(flame arrestor off, power filter instalation) will need log and change on the VE in case of.

I have same problem with 2009 model

The .xml PID list does not work for me. I entered a support request with HP Tuners.

can i get this added to pats 2012 f250 6.2l op brbm283

Have you seen what gains to be had on the dyno? Im interested in if there's a point where it will not gain any more power with more timing

I can?t believe all those codes mysteriously disappeared. There were codes for driver seatbelt, park assist, airbag, blend door actuator, etc?....

thanks for the information dave its greatly appreciated. the tuner has a shop and is "well known" in the mustang community so , my buddy reached out...

I'm just an old retired dealership guy who knows wiring diagrams, diag, & initial setup stuff way more than any actual tuning.

Oh that makes sense. Do you recommend the hp academy? I know some basics but definitely not even close to most of you guys here. I can change parts...

WOT won't be affected by a vacuum leak. Idle & low speed, sure, that would show up with very positive fuel trims down low, the effect diminishing the...

thanks mike, if you can shoot me his information that'll be greatly appreciated but if i was to return it to stock how could i do that since i cant...

It has nothing to do with what MAF curve is doing or screen resolution. Literally all I?m wanting to know how to do is change the ?airflow? legend on...

Whoaaa hold up. I may have found something. No wonder I haven?t saw any codes?. I hooked my old scan tool up to do a whole system scan of ecm, tcm,...