Activity Stream

agreed. Some people LOVE to hear themselves talk that's for sure..lol.

That still helps, thank you.

For the fuel lobe I had under cam changes in the first post. But as GHuggins points out, it can be done much better in the way he shows. The Y...

shoot you a PM

Just found out the fans will turn on if I unplug the maf. The truck idles smooth but fans will not turn on but once I unplug the maf the fans kick...

Reading more on the Flex Fuel, I understand better that the wrangler OS did not have it enabled. I have put in a support request to see if a patch...

I'm guessing this tune has the best stumped? Maybe this PCM is garbage to?

Thank you...I'll go log some time on it now and post.

There are several areas for improvement on the tune. But it sounds like you need to check the coolant system first. Was it topped off with coolant?...

Stock

If the Gen 4 to Gen 3 Knock Sensor "adapter harness" that you purchased has 2 of the wires coming from the Gen 4 Knock Sensors, that then plug into...

try changing these tables just like the inset here Under torques Management ETC torque Management. see if this helps

And yes, very different to a dyno reading. Unless the dyno sheet is from an engine dyno.

All the same. Can't remember which one but one of the engine ones clips at 850Nm or thereabouts.

The engine torque tells the trans how much line pressure to apply. E.g. you're making 1050Nm on the dyno but engine torque PID shows only 500Nm, the...

https://forum.hptuners.com/showthread.php?58447-Dodge-PE Is a good thread to help you out. ...

Where the engine went "dead" appears to be DFCO. Lambda went to 2.0 and it was decelerating. The fuel source didn't switch immediately but I...

Niffty little tool you guys built, I have gone even less than 25% i have been pretty close with 10-15% factor. the good thing is you can dial this...

With forscan you can read and save each module in the vehicle, once you put the replacement in you have to reprogram it with the as built data, i...

Thank you. I saw that, but don't understand it. So that leads me to a question. Since it isn't the expected 1.0 for stoich is this just a modifier?...

Sounds good, thank you. I'll watch the video later today and try your suggestions. Right now my attitude is 10% is 10%, if I can do better even...

Buggers, went to edit because of typos and accidentally deleted my earlier response.

as for Timing , it's more complicated, this is a good video to get a grasp , but some of what he says is WRONG for PreVVT Hemi's engines. the NON...

I did use converter box for crank and cam I used the gen 4 knock sensors just got adapter harness for them I used all gen 4 sensors except the...

Thank you, I just bought a new sensor from GMParts. (I dont want a Chinese counterfeit) I'm reading many places that the stock GM sensor has the...

.0688 is the stoich value for gas , , so it works like this the computer uses what ever setting you have for Fuel>General > Stoich then add from the...

its built into the flex sensor no extra wiring or anything it just adjusts the hz to compensate the offset i assume, sorry i put IAT but i was...