Activity Stream

That is a mechanical fault that must be diaged. I've seen that code when the cam reluctor wheel bolts are loose. This was a common issue for...

You would be better off not messing with that stuff. The base running airflow is the key to all the idle stuff. Beyond that cracker can be...

Good luck. There is not much sharing when it comes to the boosted side of this MG1. I am up and running with our car as well. 35-770 turbo. I found...

how do I check that? how do I check that? I found a log all the way back from 2017 and that side was still jagged. not that it couldn't...

Most of the PE stuff is pretty easy to understand if you hover over it and read the description down low. A lot of trucks and especially work...

I'm not sure that will positively ID that. There was a HPT version or something where one bank o2's were set to default poll much faster than the...

I think you need to be looking at drive shaft critical speed calculators. But you need more information on the thickness. You might reach out to some...

Some fast torque exit/entry stuff will show up like this on a manual too.

It's not unusual for a untuned setup to not idle and take it to the extreme.. if the tune is far off nothing will idle ever. Fix the tune for the...

I understand the gear doesnt really make a difference when your driving on the street. On the dyno doing a pull it makes a difference as I will...

forgive me if I should make a new thread instead of hijacking this one. It just seems close / relevant enough to continue here. Running a stock...

the beta installs in parallel with the 5.0.4 version, you need to select the correct version.

Look at the file name. edit: Just because you can't see it doesn't mean nobody can.

Not updating editor. You need an older version.

As I wait for HP Tuners support, I'm looking a bit deeper to see if I can figure out why these values would be what they are without making my...

I have dumb question on the 1999-2004 Mustang what timing selection to use for adding timing mainly wot I think it could use a couple degrees . On...

Ill do this tonight when i get off work. Hopefully i can grab mpvi and laptop from my brother and get yall a data log and have my wideband in

I've been successfully able to read/edit/write a handful or so 99-04 mustangs with 2 different MPVI2 (both non+). One was a friends, so not sure on...

Thanks for that, so now theres no way disable the catalyst test? I must be missing something here. Is it just a matter of updating editor?

Brooksville, Clermont, Tallahassee. Im in Brooksville but there is a thin section of high ground in the middle of the state that called the mid...

(stock file: ) The stuff you can't see is because it was removed, not grayed-out. It just ain't there no more.

So when you run headers and remove the post cat 02 sensors....and remove the code etc, it still runs the tests? Interesting. So I would assume when...

Where in the heck in Fl. is 220 ft above sea level besides the top of the sunshine skyway LOL

"ChatGPT is the end result of someone assuming that if they gather up a large enough pile of sh*t it will spontaneously generate a pony" or in this...

Thanks for the quick response. I am located in FL about 220 ft above sea level. The injectors are the stock 5.3/LMG injectors I think at one time I...

This certainly seems like the simplest test. Then Ed can tell him again what this test is telling him.

Disconnect fuel and I'll bet it will run on spray.