Activity Stream

Just to be clear on this. I have a 2007 L59 5.3 that I added a turbo to. Now I need the 2 bar VE table OS with RTT would be nice. My stock OS tab is...

Not to hijack the thread but what was the outcome on this? I came up with the following: (5-0) / (4.75-.25) = 1.111 and then 0/1.111+x =...

I couldn't get it to work. I may have set my run start location to the wrong spot, so telemetry missed the first ~second of the run. I finally redid...

thanks that seems to be the consensus of what ive been reading up on lol

no on the ve table, ill have to watch more vids. yes on the maf but i have a breakout harness for intake air temp on the lid. ive got a wideband...

Last question, and thanks for putting me on the right track. I've been entering my bin file into tune translation service, but it appears to do...

i have a 3200 in my nag1 and im going though the same shit i been scraping together trying to get the tuning school book spent 10k ona 6.4 swap n im...

I can't view your logs, as I use 'the other' software. I had some drivability issues with the control pack strategy. (Mine would throw lights if I...

why would it command a 1.00 ER while im still wide open?

First add fuel until you achieve 11.2ish AFR in boost across all rpms Then: Raise engine rpm limits cutoff drive limiter table all to 6400 TCM...

appreciate your help. do you think i could be running out of fueling at the top end? here is an updated log.

Sorry, look at 6:45, I'm rolling to a turn off the pedal, it shifts from 2nd to 1st at 10mph, after I complete the turn and get back on the gas it...

do you have an hptuners mpvi and have you installed the editor and scanner into your laptop? if so then have you paid for credits and used the editor...

I have a Factory Five Coupe with the same motor setup. I just have minimal miles on the car and I have similar issue except mine is a "dead" spot...

ngk 4610 i believe. gaps at .027

Found it wires were Frayed on rear.

Yes E38

Off to a painful start......

Yep. Especially with the stock LSA injectors. Aftermarket injectors help some and from there it's using the transient tables to make it "better".

Glue some wood strips to the deck surface for the router base to rest on, then simply set the downfeed for like .030" depth of cut and zip zip zip,...

Just to make clear: Both cars here have DBW throttle bodies, so no DBC is needed and tested. All 3 PCM:s seem to control the throttle blade according...

Not everything was done to the car all at once. I installed the cam and had the car tuned (car ran fine and no problems to report other than the...

Thank you for taking the time out to review this. I have added the stock file to the attached files. I will also attach the cam card. About...

what plugs are you using and what is the gap set to?

In theory, I use pcmhammer or lsdroid, but in reality the only thing I have used .bin files for in ages has been parameters that HPT no longer lists....

what mods were done and do you have a copy of the stock file?

Unfortunately, transient problems plague all those adapter plate setups. I don't know if anyone has figured out a real "fix" yet. Seems like most...

No reason to change that table to 6.4 unless you want to disable traction control and ABS. It works good for the track and dyno though. That table...