Activity Stream

What about bushing the rods down to .912? Would have to shorten the Ford pins and add lock grooves, but that's a damn sight easier than doing a...

2. One is for your MAF table adjustments, and the other is for your VVE table adjustments. Post your charts xml file. I log file and tune would...

Hi there, I have a 2016 Hemi and am getting into tuning. I have very little experience in this area so I am learning as I go. I have a very...

I just opened up a few GMPP stock files.. None of them had 0315 active.

Here is my Data Log of the Audi Cold start to operating temp. attached also is the vcm editor stock tune file. im just curious what my plan for...

Should be able to resize them with a rod hone. If you're trying to be critical and think that's too "loose" of a method you should be able to...

My guy at machine shop said he cant do the pistons. Only size the rods.

CKP relearn is only for cylinder discrimination during misfire events, it's learning the pattern of each tooth on that specific trigger wheel as read...

so it seems i need to drop to a 2 bar map sensor and then clamp it to be able to use the full 5v sensor for best resolution and go over 14.7psi. is...

It was a few weeks back when I had him bring the truck by so I could pull the file from it... If memory serves, yes, that example looks familiar. It...

try this and if it helps dm me

I will give it a try with the shorts on.. stage 3 cam ,vvt deleat thanks for the quick reply

Thanks, I'll check it out. As an aside, I did have it screw up on me Friday night and was able to pull over and found I did not have 12V to the...

Hello, i noticed this Thread here in the forums. im new to tuning and i have a 2010 audi A4 Quattro 2.0 Tfsi Base. Caeb. I Installed a Borgwarner K04...

sorry wasn't able to see the images you post on my phone at the time I posted the comment. Just to give update I downloaded the tune to the truck...

Your Roush exhaust system already helps unleash power, but you can upgrade with additional components like a high-performance catalytic converter or...

That is what I was hoping for, thank you!

The smart cable only needs to be installed when a tune is being uploaded to the PCM.

Do not mess with your charge temp bias.

IAT is offline too. Nothing in the tune can cause this. This is wiring/ mechanical.

yes it is a hard limit but there are work arounds like clamping the map sensor

thank you.

Also, yes, the valves are only 1.72"/1.38" but remember they are feeding an engine more than 80 cubic inches smaller than a 350.

Have seen same behavior when vehicle had non-OEM grounded O2 sensors and there was negative input offset about 70mV. Disconnect sensors and check...

It is clearly 4th gear slip. Revise 2-4 servo.

It needs to be able to move a car around under its own power while the 350 is out and getting freshened. If it sounds cool and runs better than...

cheers, its in the shop now for billet TC so will update and relog