Activity Stream

Looking for an easy one-click solution other than the things that were already pointed out?

What pump and pressure regulator are you running if you havent already mentioned?

I once had a customer's car, a 1960s VW Beetle, that had stick-on Dymo labels next to the dashboard knobs, the one for wipers was labeled...

The OP had a tune file with a VE table filled with all zeroes, and said he had no idea how or when the custom OS got applied, which means it probably...

Did you get this figured out?

Nothing about your setup should be any different with the 850W fan than it is with the 600W. The control strategy for both is identical. No issue at...

Ovate wire is a hack workaround when there's no other way to get acceptable clearance from coil bind. Conventional round wire is stronger and less...

Ordered fuel pressure tester will know PSI in next day or so. I have a new filter/regulator on-hand, but don't want to change anything until I get...

I just did a couple revisions tonight and have not logged it again yet with the changes. I will load it up tomorrow. Anything you prefer to be...

Logs will help too, so that we can see how it runs with the changes you made.

I appreciate your insight, Sir.

Have you done any tuning with the new turbo?

Hello, I'm also from Wisonsin

If there's only one pair of high speed CAN wires to a module, then it's got an internal resistor. (I had a whole thing already written up here but...

Your 43.0688ci would be a 3.891" bore? Which would be .111" overbore, not .030". The way you deal with the injector thing is, you get the part...

Correct me if I'm wrong, but the max torque tables 1-3 seem to not be in use , as the TQ hysteresis low and high are -7000, so raising or making the...

3.78 + .030 = 3.81 3.81 x 3.81 x .7854 x 3.622 = 41.2942

Whats up brotha, I had this happen to me the other day.. low voltage to the pcm is what I would assume happened and or HPs servers had a hiccup, mine...

Honestly, they don't check the levels, if they do service it, they put back the same amount they take out..

Good thinking - I have not, I’ll have to log and see. It does sound very similar, did you have to do the same thing to get cruise working...

You can raise the startup airflow delay, start with 50 crankshaft revolutions.

Thanks for all the help. I got it to start right up. I don't know if it was just one thing or a combination of things. Below is the list of things...

Thanks. I changed it to 39.