Activity Stream

Show us the .HPL and .HPT with the current changes. It's likely, if the NBO2's and the WBO2s do not agree, one of them are wrong.

Well, time to start a support ticket

If it's successful forcing OL will the O2 sensors still show voltages in the scanner? From what i understand it will still show voltages but the fuel...

Ok so pressure ratio, vs RPM and log STFT+LTFT Eq err. But first need to figure out my oxygen sensor issue which is awesome since i'm about to tow a...

Do you have a read out of the ecm and TCM that you have now?

No, it'll be the steady state model output. It may not be available to log yet, but it exists. Same as VVE airflow does.

Yes you can do that BUT the newer strategies do not use the EBP sensor and the older ones did so you might find it won?t work how you want it to. ...

So for logging MAF it's MAF airflow and for logging the NN VE table it's what dynamic airflow instead of MAF airflow?

I could not get the fast adapt relearn to work either, just kept saying sump temp too low, even though data display screen shows fluid temp at 180F....

Thanks Ill check it out !

alright here a little cruise and wot airfuel looks alot better at idle and drive along with decel but pending check engine light for bank 2 stuck...

Yes.

The only emissions equipment not there are OEM O2 sensors and pipe in place if the OEM cats. My only goal as of now is to get the OEM cats installed...

how im trying to get one on my 2013 5.0 would love the help

Hello everyone. So I wanted to update you all. I?m really going down the rabbit hole with this whole deal. I enabled my short term fuel trims after...

if you remove all the emissions systems and do not uncheck any boxes a 20 min drive should definitely set the following codes: **with the...

Ok i added all the O2 sensors and very short log but they are all over the place. cleared the DTCs and they are all back again

I am logging O2 sensor voltage now and they are all over the place the #1 sensor is all over the whole trip and the #2 seemed OK until i parked then...

Yeah I that was something I had the shop doing my work checked and was informed that everything was timed and lined up correctly. They took the...

a bud look at the throttle craker air flow table. see how i took the point out. i was told to remove points. mine seems to idle alot better. dont...

Stock it absolutely dipped. Just not as noticeable with a stock camshaft. I end up removing a lot of startup flare spark retard as well on cammed...

did a log for idle on first startup on that revision get off in an hr for a driving log

Looks like Tooner fat fingered that one.

Yes. The only time you have to pay is when you want to flash a tune change. You can read the tune and record a datalog all day free of charge.

here is the stock tune, and the issue starts in the 4 min 20 second range. If you scroll through i am logging CL on/off and you can see where it...

have a tune to go with that log? 70 msec of fuel is a ton

FYI, I was able to read/write with the setup shown at this site, ...

this is the log