Activity Stream

That's a pretty aggressive setting. If you're hearing it and seeing it in the datalogs, then it's real knock and needs to be addressed. Are you...

It's removing a lot of timing for sure...Even under light loads. It certainly appears to be false knock. Possibly a faulty knock sensor or...

Do you mind me asking what you did for a ECU? did you use the 2017, the 2013 or run them as independent systems? Did you have to make any changes to...

I see...so it's a scaling issue with the PID. That sounds like a software problem to me.

a new form of haiku, clearly 4:6:4 syllables.... lets see... go to the store buy a computer with not being locked

Thank you for the response, I appreciate the feedback. Performance boosts will continue to be a priority wherever practical, especially now that all...

For best results, all tables that are marked for training should be filled in with accurate data. You can do a regular log using VCM Scanner and then...

Why are you trying to run closed loop with one of the O2 sensors removed??? The wideband has to be either used alone in open loop only for tuning, or...

CASE relearn? Its honestly not important. Its only used for calculating misfires. Just turn it off for a swap.

i don't blame you I feel super lucky mine got going again

i think its the bank 1, its going up to 2,140mV and down to 1,307mv while bank 2 860mv to 18mv no codes showing tho

WOW, thanks for that. I really wish I had that for my Cummins Dakota, TDI JKU and TDI XJ swaps!! Would have saved a lot of trips to the dealer. I'm...

Will do send my your tune file benttrailpoolservices@gmail.com or upload it here. I'll fix all the speedo and the cat stuff then let you know which...

Good to know. Thank you, sir. Just one more question at the moment: I'm starting to tune my network by addressing one table at a time. For...

Are you looking for the tune Whipple supplies?

I can confirm the pinout is proper (I have my notes from checking the wiring earlier). Early in my diagnosis I was getting the following four codes....

Im ure your aware Mopar Connecter will have all the pinouts for the pcm and senor connectors. I just finished a 2017 5.7 hemi into my 2013 3.6 v6...

I'm 100% the math is right to get the torque values I got, I am not 100% that the resulting number is correct. I noticed the commanded torque drops...

No need to scale the MAF for 11psi unless your maf located on IC

Change ECM 2869 back to stock. See it all the time. People don't understand what that actually does.

Thank you very much for the reply Dozer. I was beginning to think I was asking too technical of a question. ;>) My truck does have the 8HP70 trans...

Yes, those 5 tables look right for a FCA vehicle where the intake and exhaust cam angles are linked together. Make sure to uncheck "use table for...