Activity Stream

The other thing is Closed Loop has been disabled, but LTFT's are still active and showing 5.5% in most places.

Low Octane spark table should be the one referenced when running in SD. You might think the MAF is failed in order to run SD, but it isn't. No...

..... searching I've done, I've never heard of an accumulator being used. I'll dig a drawing out later to see how it might work.

Geez, if you can keep the flow up, 500kpa should keep the clutches together. You're breaking new ground, for the time I've been around and all the

Thank you for your input. I agree with 24 degrees possibly being the issue, but I also feel like it should be able to take 20-22 at the moment or...

what a weird set up i was just reading about that pump the other day zero experience but holy shit... it said 145 psi was max output be careful...

Thanks a lot, Ill try to find another way improve fuel consumption

naw that doesnt work cuz if you were measuring from there the ICL number would decrease as you retard the cam and we both know it increases when...

I'm not making a vague hint that it is the reg for sure. Do like you're saying with the tank because that makes more sense. What I meant was it is...

I'm only thinking about the oil pickup being uncovered for a few seconds or so. Just to throw a number out, I'd say 5 seconds max, because that's a...

Ok update Airflow>Idle>MAP>Characteristics with the values for that sensor. Pick either 2bar or 3bar OS. Still need bigger injectors than 42lb...

Something was masking the problem. You've done a lot of good work with the fixes you've made. I'm sure you'll get this one figured out, too. ...

https://www.customecm.com/tune-file-repo-and-info-here/bench-harness-pinouts

In the 6.4L stock cam example above. ICL is 120.5 crank degrees ATDC (on the intake stroke) ECL is 120.5 crank degrees BTDC (on the exhaust...

keeping that last part ^^^ in mind, and working backwards to the intake center line from tdc, the middle of the lobe is effectively where??? its...

Around 2000kPa is the pump relief. Hard to answer min pressure, would depend on shift pressure settings etc, but you'd want as much as possible....

I'm not sure it would be a great idea to run the engine with an unknown/no calibration in the trans.

Possibly the reason this problem was being masked was the lack of exhaust getting to the turbo. With the gasket blown out on the crossover flange and...

Good evening Sirius... or anyone else still checking in. I had a chance to go for a little cruise in the truck today. I put my camera snake through...

Jesse sent me a message stating he does not do that work any longer. So apparantly it is possible to run an E67 on a 24x signal. Now to figure out...

Glad to hear, I'll give it a shot tomorrow and report back with my findings. Thanks!

Yes it should work, Ive never done one on HPT myself. Definitions are more limited from what I've seen but if it opens the virtual read file you...

Thank you sir.

im old school ill go thru the log with no filters/cell hits and just grab the parts i need and add to the VE and then build it all out to the...

if you havent figured it out yet, I had the same issue. Remove the radio fuse and you should be good to go.