Activity Stream

2425 - Power Enrich Throttle Bypass Delay: If the movement rate for the delay timer is higher than the P.E mode check, the delay timer( 2464) is...

PE isn't exactly what you need to be adjusting to "make the engine more responsive".

#450359 that might have been what he was referring to, but that's not what I was asking for and it doesn't really make sense in the context of our...

Before you get too far into tuning anything, what's up with your injector data? So you swapped the '07 LC9 for a 6.2. Still using the '07 LC9...

If you don't need an IAT2 why not buy the connectors and just pop the terminals out and plug them into the E38 connectors? 2 wiring diagrams and a...

And lemme guess you didn't get a data log of it. :rolleyes: If it fired up by opening the throttle, do it again and try to keep it running by...

servo in the trans? do im using stock. should i put one in and which one should i use. also what would this do for me?

feels like and looks like its running better, ltft is closer to zero now. still needs work though. sometimes when i hit the throttle it bogs down...

Yeah I thought about doing that but I was hoping to keep the harness that's already installed for the E67.

I love this forum. Especially all the "Nah that ain't it" replies. Spark smoothing is still on. Red arrows are spark smoothing. The...

There's nothing complicated about that setup. Very simple, should run on any roughed in SD or even "MAF only" base file. Post a tune and data log.

No you don't. Just duplicate / delete the parameter in the graph setup.

I have only just back to this car but here a log of the problem going up though the gears with the throttle closing and a long of just a third gear...

bring it by

Also again what channels do i need to have?

I installed 5.1beta and I still can't edit Virtual torque tables. The scanner is the only one that says beta. Am I missing something here?

It was spark smoothing all along lmao. I wish I had asked earlier but I thought I could figure it out on my own. I just would have never expected it...

Tune and motor install was done by a now defunct shop out of Anaheim called Stack Performance. Compression was provided by Stack.

The knock could easily be false I had forgotten your combo.. just scrolled to the top and reread it Whose tune is that? I don’t care how big...

n/a ecu can run w/g solenoid can be wired into any ecu bf different to ba ecu if need help hit me up

I’ll do a compression and leak down on it to get a sense of condition but I don’t think it’s hurt. Has good oil pressure, doesn’t smoke, no rod...

just the one and that was the result with that tune. I took it down another 7 on the initial and it's not really moving the startup idle off of 1200....

I adjusted all the friction tables. Did you try it like that or just the one? Yeah I'll help.

the file you adjusted was from a couple of days ago and when I loaded it, it would die so i put the original back on the truck. I just moved the...