Activity Stream

All I have is "crank" relearn. Why doesn't the 411 have a case relearn, and while we are on the subject it never seemed to require it even after a...

هi got the same model as you and still looking for a way to make the car riv sporty like the late srts but it will always feel like it shocked in the...

Thanks for the reply Ben Charles. I am aware of the virtual torque table. Will changing eq ratio coefficient table lower reported engine torque and...

I heard lund can do tunes. For headers. Lol

Any update to your tranmission tuning (stock slushbox issues) ...I'm hoping it changed the car 100%

i would definitely recommend getting a pmas, they actually flow bench their maf housings so the data they provide on their website is needs very very...

Now that I think about that experiment again, I think 35-38% duty cycle and below was where there were problems, no matter the load(pressure) against...

geneass, how did you install the Walbro 450? I played around with one in a stock Delphi SUV fuel bucket, and tee'd into the pump output to feed the...

LTFT Boundaries are changed all around, same with Mode vs Airflow (???). Setting the LTFT Enable ECT really low may sound like a good idea but all it...

Dont do any WOT tuning until you have a wideband. I would set the PE Gas EQ table back to stock and don?t touch it until you have a wideband. Also,...

Min Rich/Lean and Max Rich/Lean are both set to 450mv. Go back through your changelog to see when/where changes were made.

Check out Goat rope Garage on you tube, he has some great gen3 stuff. 5FDP (member) gave me some really good advice on my electronic throttle...

There really shouldn't be any reason to add that much fuel to the power enrichment. You would only need to adjust the MAF or VVE to add or remove...

About 51 psi at wot

So I was able to mostly resolve this by bumping up my LWFM above 42% throttle. Needs a little smoothing at the transition between 31.3 and 42 but is...

It varies with boost level, less timing before and at peak torque then ramp it in will help you top end some. The stock rods are weak so you don't...

You need to see how many credits your vehicle takes to license. At a minimum you need 2 credits, so that is $100. Your total would be $400 just to...

What is your fuel pressure doing?

The 6 speed is used up until 2018, that's why I said it came with the 4.3 and 5.3 engines. The 6 speed was not offered with the 6.2 past 2015, so...

Awesome thanks for your help ill do some research and go from there I feel I'm not to far off

There?s lots of videos and stuff on PID control. It?s complex but it?s best to try to get a good of an understanding of it as you can before just...

any advice on the best place to start learning about them other then google search i looked through the forums and couldn't find much

Whether the pump will keep up or not highly depends on how much fuel you are trying to pump out, even if you are on stock injectors, health of the...

The issue is resolved. I had too much converter slip while it was engaged. Raised the minimum tcc values and no longer have the misfires or slight...

how could i tell which PID control is limiting the rail pressure from reaching desired?? i dont 100% understand the labeling in those sections. cant...

Rail pressure desired follows the axis units of the rail pressure table, that is engine rpms and total fuel commanded. If the actual cannot keep up...