Activity Stream

Hello, I'm all ears in this matter as i have to do pretty much the same for my first registration. /Christian

https://us.haynes.com/products/chrysler-300-05-18-dodge-charger-06-18-magnum-05-08-challenger-08-18-haynes-repair-manual?variant=46926530183418 ...

- would it be best to use torque management?

What would be the safest way to remove power from the car to allow a new driver to get comfortable. Ideally would be limiting throttle opening to...

This is the point, don't guess, especially with the Gen 3 stuff. Relying on the stock knock detection system with a modified engine and 20 year old...

You will not be able to write one of those ecm's without GM programming software. HPtuners cannot do it. I'd keep the 07 tbss a 07 tbss with the...

Late GEN 4 trucks are pretty picky on fuel/timing. I'd try a tank of 93 or a tank of E85 only if you have a flex fuel sensor equipped truck.

Just update the map sensor scalar and offset for the map sensor you are using. Some early LS7's used a different map sensor but by around 2008...

None of those codes were in the log. Maybe you are looking at old permanent codes. My advice would be check trans fluid. Most of these cars...

10-4, I'll dig into it a little further. Thanks!

Misfire diagnostics are going to be useless on a build like this. The rest of the tune looks like you copied out of another file. There are many...

You are missing the commanded PE by a decent margin at WOT early in the pulls. Timing could be higher when you not making so much boost. You...

You had wrong parameters in your Gear Ratio & Tire Size Calibration. Give this a try and see if anything changes.

This looks like a regular miss to me. Look for a cold cylinder at idle. I do not think this is tuning related.

Gen 5 is a tough place to learn as a newb but kudos to starting. To tune WOT AFR, you need a wideband. No exceptions. to tune closed loop AFR, you...

Thanks horsepowerguru427. Idle is much more stable now and the revs are dropping off faster. I still need to trim the fuel a bit and still want to...

They're not unrelated. They both are the end result of a jacked up toon.

ok, so i'm following this guide: https://forum.hptuners.com/showthread.php?31591-How-To-4L60-65E-trans-tuning-Shifting-TCC-TM-(w-Pics)& BUT Can...

I have a similar problem with my 2014. I have ECM, TCM, & FSCM unlocked and after I connect to the car, and open up special functions, Fuel pump...

He did that frequently...

Tires are 29.5" Its shifts 1st to 2nd as should. It never shifts out of 2nd i think. At full throttle it shifts 2nd to 3rd but wont go into 4th. ...

I removed the headers to apply heat wrap; the gaskets show signs of multiple exhaust leaks. I'll update again if this solves my problems.

I believe these two issues are unrelated because the idle problem can be reversed just by swapping hoses back

Yes, I guess I should have more detail. I bought the whole engine, ecm and pedal out of a wrecked C6 Z06. I installed it all unmodified and unchanged...