Activity Stream

Thank you for the reply and information. Please elaborate on this issue with the SD calculator, and I am sharing my thoughts here with the same...

You're welcome.

Thank you so much for this Sirius. I got all my answers thanks.

Where are the data files stored? GPS calculations are often inaccurate. capybara clicker

The filter will help because it's looking for stable airflow rates. This means error measured during stability will be accurate. If you try tuning...

Thats exactly what i am looking for. do you think filtering will help me to log VE table? or i need to enable my Stft and Ltft. can i tune without...

its pulling 6 degrees of timing commanding 16 but yer only seeing 10 what is it making? 7 or 8 psi? do you guys not have e85 where you are?...

I see. yes i want to run SD full time. I think i get an idea where i am lacking i will give it try in morning. Thanks again

Change the Fuel>Transient>MinFuel Milligrams to .022. I've had this parameter really mess with my idle. It's derived by Min Injector pulse width...

You mean you want to run SD. Make sure you've failed the MAF correctly. That lean spike was probably during a tip-in or -out transient. I like to...

yeah i got lean spike just for 3-5 seconds on wide band i log for misfire no misfire was present. I want to use my MAP sensor all time. but still...

If you're already that lean that likely means you haven't taken the time on the low end. Start slow and don't burn your stuff up.

Oh i think get it. it was just a test log i forced my PCM open loop and Disable STFT n LTFT. I am using AEM Wideband I got my lean AFR at WOT around...

The data doesn't populate because you're missing the PIDs for AFR Commanded as well as AFR for whichever wideband you're using. AFR Error math needs...

Strike three. I give up.

set up mine like this.

If you don't post the default.Graphs.xml (or the .xml for the specific graph that isn't working), no one will ever be able to give you an answer,...

i am dealing with this same thing on a drag truck a buddy is racing its for off road use only and i cant find anthing to help me ive disabled...

Ahh ok. I'll redo the data for you.

EGR on that file is already enabled, and also has values populating the egr airflow and spark correction tables. If you use the already enabled...

it doesn't populate anything here. It just moving around all cell without showing data. Did some search on google and seen some videos on youtube did...

i shot you a dm email me the tune

What data doesn't populate where? When you give your log file to someone else and they open it, all they see is the data from the channels that were...

Also setting up the BlueCat template properly is key to getting the proper outcome.