Activity Stream

The trans does this on both the tuners trans tune and on the factory tune. Here is each

you did not state which controller you have or what year it is but i will still say the answer will almost always be "never". you should never touch...

TTS recommends unlocking it in lower gears so that when you stab the pedal, but don't go far enough to force a downshift, you get a flash of the...

Your trans has constant gear slipping when steady in 4th gear. Look around 1:50 log time - calculated gear ratio fluctuates around 0,85, but 4th...

Which are?

@aaronc7 So I have my tcu with corrected shift definitions. However I'm getting a "Transmission: malfunction can continue to drive in D until engine...

do those still come with a free bag of wrist pin boss return springs?

what happened with the first revision

Maybe tomorrow on trying that rev2. It won't be towing though. Probably just driving to work.

i would try to make certain that OS 56029268AI was compatible with part number 56028957AF and i would find out what they used to change the VIN ...

when are you gonna upload a log of a putt running that first revision?

Post your tune

Yes, this seems to be a mismatch between the ECU's actual OS (56040145AC) and the OS stored in the read file (56040145AD), which HPTuners sees as a...

You have to spend a lot of time on this forum trying to understand what should be tuned when any modification has been done to your car. Basically...

I'll look for the files and post them here, maybe it will be useful for you, most of them are from configured machines that have traveled a long way

Maybe this will show. Not sure why it wasn't showing the first time I posted it

Hotwire auto built my harness and wrote the VIN into this PCM. Pretty sure HPTuners was used for that also. 2005 Ram was PCI based communication...

Vcm beta is what i was able to reboot-update & fix my device when my mpvi3 failed the update as well, stuck on the reading interface pop up, the...

who wrote over the original VIN that was in that controller? what did they use to do so? what wiring harness did you use to do the swap? ...

Not on the stock 1bar OS.

I KNOW I tuned boosted 98s with right MAP sensor data in them??

The file that guy posted was absolutely NOT a factory stock file. The stock rev limiter is 6200rpm, the stock speed limiter is 155mph, and while the...

the quality of the tune is directly related to how well the customer can follow directions

I took a look at the above 04 gto m6 stock tune file in VCM BETA and seen it says the speed limiter is set at 255mph. Has a place to enable the...

If I’m honest not much..I’m a mechanic by trade but just now getting into this side of it, the most I’ve done is swapped my throttle body reading...

Another interesting item on this log. The FA increases but it stays in CL. It's almost like the FA is increased based on PRatio or MAP when under...

I do not have FA enrich or FA power enrich channels available on this NGC3 PCI PCM

Here is a shot when not towing just cruising a 2-lane road and going up a slight hill, not drastic at all. Increases FA significantly more than the...