Activity Stream

That's fine I know which ones from your description. Here it is for the current setup. When you get the MAP installed change Airflow>General>MAP...

The one that says GM data. LS1. 0kPa column for all columns of IFR and Offset if vacuum-referenced. Set your O2 switchpoints to 451. Not...

The TMAP sensor is a combined sensor, with both a MAP and a temperature sensor inside. The wire harness then connects the 4 pin side to the TMAP...

which table would you recommend for a 5.3 under the gm data then?

Message: Man, I?ve been chasing that IAT. Plugged in. But the reading comes from TMAP no? It recently came apparent, under the proper spec MAP...

P0630 definition is "VIN not programmed or mismatched". Your tune apparently has no or a wrong VIN number. If you can't get this resolved with your...

how do you adjust o2 delay on a NGC3 with hpt? I cant find anything

Thank you, great support!

need to get it up to operating temp and closed loop. did you do anything to the stock tune, or just hoped it works? What have you done? ...

I have not checked the fluid level. It is under warranty by the dealer which is doing all servicing so im hoping they are checking things.

Is the dealer my only option? I just read on here that some one was able to read with smarty installed. Is that feasible? Im not trying to sound rude...

Multiply all misfire tables by 2 or 2.5. At that point it will still come on with a pretty aggressive misfire and still point out a single missing...

https://forum.hptuners.com/showthread.php?95565-Ford-6-2-Swap-and-tuning&p=729802&viewfull=1#post729802

It'll be a good start. Looking forward to your results.

Alright. I did get those changes made...trying to keep a log of these changes, within reason, so I can learn how this stuff works. If I like what I...

Anyone have any luck with this? I read that the engine side of the Gpec5 and Gpec2 are the same, but the body harness needs an adapter.

That doesnt make sense. raise values in apply ramp to slow lockup up? As it gets closer to 0 slip the values fall so THAT should be slow ramp??

Good spot, will fix, but still at loss on the original problem

Not to be ?that guy? but this is something that should be mentioned on the site about the BRP stuff. I am having this issue with my 2015 commander...

I talked to support and they're saying it's unable to be tuned without having a dealer or someone with dealer tools flash it back to the latest stock...

It's no problem. Look here. 92kPa with 41% throttle. No PE because of throttle percentage. KR. Highlight the Hot enable table and multiply...

I would not follow anything from sloppy mechanics especially tuning related.

There's a lot of Deka 80 "data" floating around out there. The one I linked works. I've used it on 3 tunes so far. Look on the first tab. That's...

Any chance you could post all 3? Is the bypass disable switch only in newer hpt versions or something. I don't see the switch - only settings to...

Min airflow looks really high to me.. But I don't know what your cam specs are... Timing table seems a little too much at low rpm/cyl airmass....

this is exactly what I did with my 08. it comes with that box to control the normal brushed fan with the pwm. Just remove box, add c7 fan. pos, neg...