Activity Stream

output 3 of L-H setting is what I used. what fixed mine was using a 2wd tune file because my 08 5.3/4l60e came with electric shift transfer case and...

i don't know if it safe for the car or not ?

see the my last logs is there somthing missing from the log channels and i will add it and log again, i don't know how to do the table using my logs...

this the latest logs i have i tride ai for help

Im not really sure what method you were using when tuning those VE tables but Id suggest that you wipe that from your memory entirely and then prob...

Here is the work I have done with DFCO and MBT Map Points. We still cannot get burbles. There is no Burble section for this year and model but here...

Welcome What does your username mean?

how does it drive having not been tuned? what is it not doing that you would like it to do? what is it doing that you would like it to cease...

Hi all. I am in the Fenlands UK. I live in Lincolnshire but am only 2 miles from Cambridgeshire and 3 miles from Norfolk.

Thank you for the replies. So, my initial question was, Is this the equipment that I need and, is it a stand alone unit or do I need a laptop or...

Would you be able to post your current tune file id like to take a look

https://www.youtube.com/watch?v=QgXQ7RGLPoE

What does 'fuel pressure is good' mean? 'Good' for a L59 fuel rail/regulator that runs at 51 PSI base or a everything-except-L59 rail/reg that runs...

The OBD 30-0334 is for CAN-equipped vehicles, E40 and newer only. P01/P59 Gen3's do not have CAN. You should have got the 30-0300. I'm not telling...

An '05 Suburban doesn't have any sensors that can be deleted that will give it 'more pep'. This isn't an '81 Citation with 37 miles of vacuum hose...

I"ll post up a newest tune, i been working at it. Had knock down to an avearge of 1 or 2 in some areas which is way better than stock but having...

It lists rs232 communication in the AEM website listing, so I assumed you should have a wire diagram in the package that would tell you what the...

Just went and looked at the kit… it doesn’t have a rs232 plug. It has the obdII passthru

I don't understand raising the idle speeds 175 to 200 rpm over stock to smooth out the cam, then artificially trying to induce less smoothness. ...

Adjusted Overspeed/Underspeed as follows (also attached) Overspeed (0-10-10-12-12-12-12-15-15-15) Underspeed (15 15 15 12 12 12 12 10 10 0) Can...

prolly not i am on 5.1.3637 right now you need to add pulse width and more

YOU HAVE SOME KNOCK I take a look at

Update. Adjusted PE to 1.2 across board and set Stoich to 14.68 across the board. Running 12.7 at WOT. I greatly appreciate the info, help and...

Run 176: Returned the acceleration gain tables to "normal" (Run 171 values). Combined the enleanment gains into the throttle table. *WB got...

so... after racing for seasons with it all screwed up i finally figured it out beginning of 2023 season yes, it made a difference can i type...

Warning: you may go insane. Don't say I didn't warn you. I was also fiddling with the O2 Airflow delay tables, and the stoich threshold for...

Before anything else brother I would recommend you to go back to stock both the ecm and the tcm. In the tune of your car the knock sensor settings...