Activity Stream

Just the nature of the beast. It's impossible for us to have every possible stock calibration when they are constantly releasing updates. If you...

I always ship USPS Priority when the object fits into one of their flat-rate boxes, and in my experience they provide updates more frequently than...

Could also use some help with this issue. Support Nov 10, 2024, 1:54 PM Your request (458217) has been received and is being reviewed by our...

thank you

i think is best you buy the ones we all use

you gonna have to use a 260 map

Try that

I would not be shipping something like this by post office. UPS or FedEx so at least you can see continuous updates. Especially this time of year....

Well this is an LS9, not an LT4. LT4s and especially LT5s will knock unless on 100 if it?s warm out. They have even worse heat soak. Higher...

What I'm pointing out.. is fuel trims will not move fast enough to see this pocket/hole whatever you want to call it. It doesn't have to be...

Also on a related note, I can't get VCM Scanner to connect to the truck so a log file is going to be hard to provide. Thanks again.

The answer depends on the behavior of the narrowbands. If they are oscillating then I doubt there's much disagreement between the two. It's more...

I called JMS and they don't have a plug for the SUV. Finding the 0-5 volt should be easy, just need to figure out a good place to mount it. I...

Yes but I have not had a chance to test yet.

I'll echo what Ed is saying. Everything shows knock.. If it doesn't it likely has bad knock sensors. Just about every stock LT4 I do knocks...

I just looked at one of my logs and noticed I'm above 1.2 by 3500 rpm and 4 psi of boost (rolling in the throttle and stopping at about 60% throttle...

I didn't say anything about putting it in OL. You can use both simultaneously. In fact I can't think of the last time I forced a car in OL to use a...

Did you ever change the stall tq setting and see if it made a difference?

In the low-rpm area, when engine speed drops below 500 rpm. It can be coasting or unstable idle. I just need to determine tendency of VE, not exact...

If you need more fidelity in timing you can setup Boost PE to target different AFR's and then use that AFR to pull timing. does that make sense? ...

That's how The General set it up from the factory. But just know I don't have a button to activate Tow Haul Mode. I have Drive, Sport, and TUTD modes...

Oh shoot, I didn't see the .HPL when I first responded. Yes, let's see the .HPT.

Really? Just 2 days ago you were still telling Squirrel not to listen to the naysayers.

(what are the specific conditions?) I don't know if this is the right time or place but can you elaborate based on your knowledge for me/us...

Did you recheck how you have the row axis and column axis is set up and have you tried different MAP parameters in the graph mapping, it's at the...

So then, let's recap: it had a miss, you found a mechanical issue which you have since corrected. Do you have logs prior to the repair that will...

It works on my 2014 PIU 3.7

I know I'm waaaay outta my league here, but I'm mostly following along to try to learn something. I'm really curious about choosing Trans>Shift...