Page 1005 of 1241 FirstFirst ... 5505905955995100110021003100410051006100710081009101510551105 ... LastLast
Threads 20081 to 20100 of 24806

Forum: GM V8 Tuning - Engine, Gas (Gen 3)

(1997-2009, LS1, LS6, ...)

  1. Sticky Thread Sticky: If you want us to help with a tune or scan issue post your .hpt file, log & .cfg too.

    Started by jimmyblue, 10-19-2009
    92 Attachment(s)
    • Replies: 0
    • Views: 108,240
    jimmyblue
    10-19-2009 Go to last post

  2. Sticky Thread Sticky: READ ME!!! General tuning info and how-to's

    Started by WS6FirebirdTA00, 02-07-2006
    • Replies: 0
    • Views: 292,090
    WS6FirebirdTA00
    02-07-2006 Go to last post

  1. is 40deg the max ls1 timing?

    Started by sikhabib, 04-26-2008
    • Replies: 8
    • Views: 5,345
    Bill@HPTuners
    05-14-2008 Go to last post

  2. Secondary VE question

    Started by KLUG'S SS, 05-12-2008
    • Replies: 6
    • Views: 2,948
    KLUG'S SS
    05-13-2008 Go to last post

  3. 5.3 swap in a 06 6cyl manual truck tack?

    Started by van383, 05-12-2008
    • Replies: 6
    • Views: 2,906
    van383
    05-13-2008 Go to last post

  4. RAF vs. IAC vs. Idle Spark

    Started by RZRSEDGE, 05-09-2008
    • Replies: 9
    • Views: 4,087
    RZRSEDGE
    05-13-2008 Go to last post

  5. Any benifits using 2 bar SD with a maggie

    Started by red99, 05-13-2008
    • Replies: 3
    • Views: 2,058
    MonkeyGod
    05-13-2008 Go to last post

  6. why is maf and stft still working?

    Started by PHASEMASTER1, 04-30-2008
    2 Pages •
    1 2
    • Replies: 30
    • Views: 12,073
    5_Liter_Eater
    05-13-2008 Go to last post

  7. 1999 30th TA: trouble with DTCs and reading PCM

    Started by SilverTurtle, 05-12-2008
    • Replies: 3
    • Views: 1,792
    SilverTurtle
    05-12-2008 Go to last post

  8. 06 Hummer MPG Config File???

    Started by sikgmc, 05-12-2008
    • Replies: 0
    • Views: 1,300
    sikgmc
    05-12-2008 Go to last post

  9. Idle surge only if AC is OFF

    Started by rel3rd, 05-08-2008
    • Replies: 4
    • Views: 2,495
    WS6FirebirdTA00
    05-12-2008 Go to last post

  10. wont run in open loop

    Started by edcmat-l1, 05-09-2008
    • Replies: 19
    • Views: 7,128
    edcmat-l1
    05-12-2008 Go to last post

  11. I want to log the IAT Timing pulled.

    Started by Chuckster, 05-11-2008
    • Replies: 6
    • Views: 2,918
    Gh0st
    05-12-2008 Go to last post

  12. Reprogram to Flex fuel?

    Started by tahoe, 05-03-2008
    • Replies: 13
    • Views: 9,185
    tahoe
    05-11-2008 Go to last post

  13. Sd Tuned/snow Meth Controller (maf)

    Started by anarchy99, 01-29-2007
    • Replies: 2
    • Views: 1,766
    LS1408
    05-10-2008 Go to last post

  14. Fast 90 Install. Looking for a review.

    Started by 97SilverC5, 04-29-2008
    2 Pages •
    1 2
    • Replies: 24
    • Views: 10,415
    97SilverC5
    05-10-2008 Go to last post

  15. Newbie to this, few issues - could use direction

    Started by MeanYellowZ, 05-09-2008
    • Replies: 1
    • Views: 1,243
    LinearX
    05-10-2008 Go to last post

  16. Some Idle Proplem

    Started by The devil, 05-09-2008
    • Replies: 5
    • Views: 2,649
    R32WA
    05-10-2008 Go to last post

  17. VE Tuning Confusion

    Started by Gh0st, 05-06-2008
    • Replies: 10
    • Views: 3,863
    Rhino
    05-09-2008 Go to last post

  18. Tuned by Wideband...now LTFT = +4

    Started by ChrisV 02 - Z28, 05-09-2008
    • Replies: 0
    • Views: 1,192
    ChrisV 02 - Z28
    05-09-2008 Go to last post

  19. Exclamation How do you really dial the RAF in?

    Started by Billiumss, 09-28-2006
    • Replies: 19
    • Views: 8,579
    5_Liter_Eater
    05-09-2008 Go to last post

  20. Running very lean on cold starts - log attached

    Started by Gh0st, 05-07-2008
    • Replies: 9
    • Views: 3,746
    WS6FirebirdTA00
    05-09-2008 Go to last post
Page 1005 of 1241 FirstFirst ... 5505905955995100110021003100410051006100710081009101510551105 ... LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.