Page 1024 of 1240 FirstFirst ... 245249249741014102010211022102310241025102610271028103410741124 ... LastLast
Threads 20461 to 20480 of 24789

Forum: GM V8 Tuning - Engine, Gas (Gen 3)

(1997-2009, LS1, LS6, ...)

  1. Sticky Thread Sticky: If you want us to help with a tune or scan issue post your .hpt file, log & .cfg too.

    Started by jimmyblue, 10-19-2009
    92 Attachment(s)
    • Replies: 0
    • Views: 106,825
    jimmyblue
    10-19-2009 Go to last post

  2. Sticky Thread Sticky: READ ME!!! General tuning info and how-to's

    Started by WS6FirebirdTA00, 02-07-2006
    • Replies: 0
    • Views: 290,672
    WS6FirebirdTA00
    02-07-2006 Go to last post

  1. Supercharged tuning from hell. Please help!

    Started by blownbluez06, 01-26-2008
    2 Pages •
    1 2
    • Replies: 30
    • Views: 12,223
    gold98Z28
    02-12-2008 Go to last post

  2. no knock?

    Started by van383, 02-10-2008
    • Replies: 5
    • Views: 2,310
    van383
    02-11-2008 Go to last post

  3. #52 injector table

    Started by Runn WS7, 04-18-2006
    • Replies: 15
    • Views: 6,177
    4.8t
    02-11-2008 Go to last post

  4. Vortec 5.7 Fuel control

    Started by wilson, 02-11-2008
    • Replies: 3
    • Views: 2,552
    Bill@HPTuners
    02-11-2008 Go to last post

  5. Another flow rate vs. kPa table thread

    Started by MikeGyver, 02-08-2008
    • Replies: 5
    • Views: 2,569
    EC_Tune
    02-10-2008 Go to last post

  6. ETC Closes under WOT, suggestions??

    Started by 00 Z, 01-27-2008
    2 Pages •
    1 2
    • Replies: 25
    • Views: 9,456
    00 Z
    02-10-2008 Go to last post

  7. Idle problems

    Started by ct06gto, 02-10-2008
    • Replies: 1
    • Views: 1,544
    Proven Power
    02-10-2008 Go to last post

  8. ohno idle tunning

    Started by Proven Power, 01-07-2008
    • Replies: 15
    • Views: 7,208
    Proven Power
    02-10-2008 Go to last post

  9. 1bar sd ok for low boost?

    Started by marky_24, 02-09-2008
    • Replies: 1
    • Views: 1,644
    bpm
    02-09-2008 Go to last post

  10. EGR and gas mileage

    Started by bmaffin13, 02-06-2008
    • Replies: 6
    • Views: 3,411
    bmaffin13
    02-09-2008 Go to last post

  11. How to use Transient Fuel tables to prevent lean tip in?

    Started by Blackbird, 12-24-2007
    • Replies: 4
    • Views: 3,980
    bin_ajail
    02-09-2008 Go to last post

  12. WOT Timing always 2-3 degrees low

    Started by MikeGyver, 02-05-2008
    • Replies: 13
    • Views: 4,295
    EC_Tune
    02-09-2008 Go to last post

  13. IFR and Boost Reference Regulator

    Started by deckhand, 12-13-2006
    • Replies: 13
    • Views: 8,641
    EC_Tune
    02-09-2008 Go to last post

  14. 2007 GMC SIERRA 1500 Turbo

    Started by bin_ajail, 01-26-2008
    • Replies: 2
    • Views: 1,957
    EC_Tune
    02-09-2008 Go to last post

  15. LS1 98 to 00-up PCM swap?

    Started by n0dih, 02-03-2008
    • Replies: 11
    • Views: 14,327
    ls1Mulllet
    02-08-2008 Go to last post

  16. PE Enable TPS, Hot vs Cold

    Started by ChrisV 02 - Z28, 02-08-2008
    • Replies: 1
    • Views: 1,829
    00000D0101
    02-08-2008 Go to last post

  17. Help on exact steps to tune VE and MAF with Wideband

    Started by ChrisV 02 - Z28, 01-21-2008
    • Replies: 15
    • Views: 7,233
    ChrisV 02 - Z28
    02-08-2008 Go to last post

  18. tune was fine, now jumped over 1 full point off??

    Started by joshz06, 02-04-2008
    • Replies: 13
    • Views: 4,681
    joshz06
    02-08-2008 Go to last post

  19. maf sensor in speed density question

    Started by t_thall, 01-14-2008
    • Replies: 3
    • Views: 3,646
    00000D0101
    02-08-2008 Go to last post

  20. Installing PLX wideband question

    Started by ChrisV 02 - Z28, 01-21-2008
    • Replies: 5
    • Views: 3,263
    ChrisV 02 - Z28
    02-08-2008 Go to last post
Page 1024 of 1240 FirstFirst ... 245249249741014102010211022102310241025102610271028103410741124 ... LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.