Page 504 of 1240 FirstFirst ... 44044544945005015025035045055065075085145546041004 ... LastLast
Threads 10061 to 10080 of 24798

Forum: GM V8 Tuning - Engine, Gas (Gen 3)

(1997-2009, LS1, LS6, ...)

  1. Sticky Thread Sticky: If you want us to help with a tune or scan issue post your .hpt file, log & .cfg too.

    Started by jimmyblue, 10-19-2009
    92 Attachment(s)
    • Replies: 0
    • Views: 107,617
    jimmyblue
    10-19-2009 Go to last post

  2. Sticky Thread Sticky: READ ME!!! General tuning info and how-to's

    Started by WS6FirebirdTA00, 02-07-2006
    • Replies: 0
    • Views: 291,444
    WS6FirebirdTA00
    02-07-2006 Go to last post

  1. VE table

    Started by anniversaryss, 03-12-2018
    1 Attachment(s)
    • Replies: 5
    • Views: 1,401
    cobaltssoverbooster
    03-13-2018 Go to last post

  2. going lean when accelerating.

    Started by mrr23, 08-24-2015
    5 Attachment(s)
    • Replies: 5
    • Views: 2,656
    madmann26
    08-25-2015 Go to last post

  3. how to set up to run open loop tune?

    Started by fst100, 01-30-2012
    • Replies: 5
    • Views: 12,216
    flame
    01-31-2012 Go to last post

  4. LS1 MAF table differences

    Started by 02_TA_RamAir, 01-30-2012
    • Replies: 5
    • Views: 5,475
    murphinator
    01-31-2012 Go to last post

  5. histogram configuration

    Started by limitless, 01-30-2012
    • Replies: 5
    • Views: 2,502
    limitless
    01-31-2012 Go to last post

  6. new pcm

    Started by WS6funboy, 08-27-2015
    • Replies: 5
    • Views: 2,485
    WS6funboy
    08-29-2015 Go to last post

  7. Exclamation Isolated idle surge to certain ECTs in gear

    Started by BADFNZ, 02-02-2012
    • Replies: 5
    • Views: 2,444
    gn2beatu
    02-03-2012 Go to last post

  8. Dead PCM or wiring issue???

    Started by ZenithMotorsports, 02-03-2012
    • Replies: 5
    • Views: 2,951
    ZenithMotorsports
    02-04-2012 Go to last post

  9. Car misses idle on clutch in, need some fresh ideas

    Started by jimmypop13, 12-14-2009
    • Replies: 5
    • Views: 3,504
    1049766771
    02-02-2012 Go to last post

  10. SD tune going lean only in 3rd gear???

    Started by wadelieck, 01-12-2012
    • Replies: 5
    • Views: 2,639
    jakebdb56
    01-16-2012 Go to last post

  11. Whats the lowest pulsewidth youve been able to command idling consistant?

    Started by GrannySShifting, 01-13-2012
    • Replies: 5
    • Views: 2,355
    LSxpwrdZ
    01-30-2012 Go to last post

  12. 5.3 Turbo

    Started by 944-5.3turbo, 08-30-2015
    2 Attachment(s)
    • Replies: 5
    • Views: 2,602
    mecanicman
    08-30-2015 Go to last post

  13. Newb looking for some direction!

    Started by ProjectD, 01-13-2012
    • Replies: 5
    • Views: 2,587
    oakley6575
    01-16-2012 Go to last post

  14. B1S1 going to -38% and +50%. B2S1 acting normal

    Started by cjsgarage, 04-11-2021
    • Replies: 5
    • Views: 1,090
    cjsgarage
    04-11-2021 Go to last post

  15. Ignition timing spiking at idle Cammed LS1

    Started by abrowne70, 05-15-2013
    3 Attachment(s)
    • Replies: 5
    • Views: 4,182
    SSUte01
    07-20-2013 Go to last post

  16. 06 Silverado Issues

    Started by Kurtstarling, 04-14-2021
    5 Attachment(s)
    • Replies: 5
    • Views: 1,487
    Kurtstarling
    04-14-2021 Go to last post

  17. Exclamation Can someone help????

    Started by littless, 08-20-2015
    • Replies: 5
    • Views: 3,282
    mecanicman
    08-21-2015 Go to last post

  18. Just installed 98 FTP lid/85mm MAF

    Started by bene, 01-23-2012
    • Replies: 5
    • Views: 3,107
    01ssreda4
    01-28-2012 Go to last post

  19. Went 2 bar SD, need base

    Started by 357i, 01-23-2012
    • Replies: 5
    • Views: 2,321
    seven ends
    01-23-2012 Go to last post

  20. Tune/Scanner Review

    Started by CptMidway, 04-04-2021
    3 Attachment(s)
    • Replies: 5
    • Views: 1,252
    CptMidway
    04-09-2021 Go to last post
Page 504 of 1240 FirstFirst ... 44044544945005015025035045055065075085145546041004 ... LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.