Page 897 of 1241 FirstFirst ... 397797847887893894895896897898899900901907947997 ... LastLast
Threads 17921 to 17940 of 24806

Forum: GM V8 Tuning - Engine, Gas (Gen 3)

(1997-2009, LS1, LS6, ...)

  1. Sticky Thread Sticky: If you want us to help with a tune or scan issue post your .hpt file, log & .cfg too.

    Started by jimmyblue, 10-19-2009
    92 Attachment(s)
    • Replies: 0
    • Views: 108,259
    jimmyblue
    10-19-2009 Go to last post

  2. Sticky Thread Sticky: READ ME!!! General tuning info and how-to's

    Started by WS6FirebirdTA00, 02-07-2006
    • Replies: 0
    • Views: 292,119
    WS6FirebirdTA00
    02-07-2006 Go to last post

  1. What's a good lamda value for FI

    Started by schnellTTZ06, 10-09-2009
    • Replies: 2
    • Views: 1,440
    schnellTTZ06
    10-09-2009 Go to last post

  2. Starts fine but idles and stalls once put in gear cold

    Started by 99LS1SS, 10-01-2009
    • Replies: 6
    • Views: 5,721
    99LS1SS
    10-09-2009 Go to last post

  3. asking for advise on tuning for a new cam

    Started by mrfister77, 10-09-2009
    • Replies: 0
    • Views: 1,271
    mrfister77
    10-09-2009 Go to last post

  4. Moist Air Fuel Issue

    Started by aaron.kent.76, 10-02-2009
    1 Attachment(s)
    • Replies: 8
    • Views: 3,456
    aaron.kent.76
    10-08-2009 Go to last post

  5. O2 votlage problems

    Started by fmowry, 09-28-2009
    • Replies: 8
    • Views: 4,458
    Billf6531
    10-08-2009 Go to last post

  6. No timing being pulled during shifts?

    Started by TURBO 6.0, 10-08-2009
    • Replies: 1
    • Views: 1,189
    vortec
    10-08-2009 Go to last post

  7. Finally got the timing up please help me get this one little tweak done.

    Started by ssdungeon, 10-08-2009
    • Replies: 0
    • Views: 998
    ssdungeon
    10-08-2009 Go to last post

  8. developing WOT timing without a dyno

    Started by DSteck, 10-08-2009
    • Replies: 0
    • Views: 1,171
    DSteck
    10-08-2009 Go to last post

  9. Extremely Lean Decel..Not DFCO

    Started by nikon1999, 04-12-2009
    • Replies: 14
    • Views: 6,255
    muayyadf1
    10-08-2009 Go to last post

  10. RPM's dip below idle when clutch is pushed in at high RPM's, cooler weather...

    Started by slammin86, 10-05-2009
    • Replies: 8
    • Views: 3,274
    slammin86
    10-07-2009 Go to last post

  11. Potentially dumb injector question

    Started by 99LS1SS, 10-07-2009
    • Replies: 2
    • Views: 2,031
    99LS1SS
    10-07-2009 Go to last post

  12. Attention Russ K Idle Review

    Started by josh mcclelland, 08-27-2009
    • Replies: 8
    • Views: 5,492
    Russ K
    10-07-2009 Go to last post

  13. Want to use the russ k idle config on GTO, but lots of confusion...ltit

    Started by slammin86, 10-06-2009
    1 Attachment(s)
    • Replies: 5
    • Views: 3,177
    slammin86
    10-07-2009 Go to last post

  14. 98 gmc silverado383

    Started by bnt performance, 09-30-2009
    • Replies: 13
    • Views: 4,916
    Throttle
    10-06-2009 Go to last post

  15. changing PCM to newer year?

    Started by greg fell, 10-06-2009
    • Replies: 1
    • Views: 1,378
    Frost
    10-06-2009 Go to last post

  16. Low end grunt on Chevy trucks

    Started by GregRexAdams, 08-22-2009
    • Replies: 4
    • Views: 2,066
    PitchblackC3
    10-06-2009 Go to last post

  17. Knock Sensor Choice for LT1 Conversion

    Started by Fast9C1, 10-05-2009
    • Replies: 1
    • Views: 1,389
    ak95ta
    10-06-2009 Go to last post

  18. Big Cam Tuning advise

    Started by VetteHead, 05-11-2009
    • Replies: 10
    • Views: 3,962
    angrygoat
    10-06-2009 Go to last post

  19. Are my 02 sensors to blame for this?

    Started by AKMac, 10-06-2009
    • Replies: 0
    • Views: 1,135
    AKMac
    10-06-2009 Go to last post

  20. Idle surging...

    Started by TURBO 6.0, 10-06-2009
    • Replies: 1
    • Views: 1,368
    C5 2000
    10-06-2009 Go to last post
Page 897 of 1241 FirstFirst ... 397797847887893894895896897898899900901907947997 ... LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.