Page 1 of 833 123451151101501 ... LastLast
Threads 1 to 20 of 16644

Forum: GM V8 Tuning - Engine, Gas (Gen 4)

(2005-2015, LS2, LS7, ...)

  1. Sticky Thread Sticky: Read Me!!! Tuning How-To's & General Information

    Started by Bill@HPTuners, 01-06-2007
    3 Pages •
    1 2 3
    3 Attachment(s)
    • Replies: 40
    • Views: 247,769
    TheMechanic
    06-06-2023 Go to last post

  1. ECM 14072 test for missfire

    Started by obthomas, 1 Hour Ago
    • Replies: 3
    • Views: 11
    gtstorey
    22 Minutes Ago Go to last post

  2. A few questions regarding swapping OS

    Started by Agtronic, 1 Hour Ago
    • Replies: 2
    • Views: 21
    Alvin
    26 Minutes Ago Go to last post

  3. What am I missing? Open Loop Delay?

    Started by CTSVNZ, 7 Hours Ago
    3 Attachment(s)
    • Replies: 8
    • Views: 132
    Alvin
    1 Hour Ago Go to last post

  4. 5.3 Swap Starts then Dies

    Started by angelm_ix, 18 Hours Ago
    2 Attachment(s)
    • Replies: 6
    • Views: 88
    Alvin
    1 Hour Ago Go to last post

  5. Cammed Ve Ss Manual L98

    Started by troyjago, 1 Day Ago
    6 Attachment(s)
    • Replies: 7
    • Views: 143
    troyjago
    1 Hour Ago Go to last post

  6. (Almost) New to HP Tuners

    Started by Shroomun, 1 Day Ago
    • Replies: 3
    • Views: 99
    Cringer
    1 Hour Ago Go to last post

  7. Does 6l80 function safely with MAF tune only?

    Started by NastyLS3, 6 Days Ago
    • Replies: 9
    • Views: 381
    Alvin
    2 Hours Ago Go to last post

  8. Adjusting cooling fans to operate at highway speeds if needed?

    Started by [email protected], 08-05-2022
    • Replies: 19
    • Views: 2,048
    eficalibrator
    2 Hours Ago Go to last post

  9. Operating OS's 1250216 & 1250219 compatibility

    Started by Guy With A Chevy, 1 Day Ago
    1 Attachment(s)
    • Replies: 10
    • Views: 259
    gtstorey
    2 Hours Ago Go to last post

  10. Heat Soaked Restart Issues

    Started by Cringer, 1 Week Ago
    3 Pages •
    1 2 3
    20 Attachment(s)
    • Replies: 57
    • Views: 1,893
    biholliday
    4 Hours Ago Go to last post

  11. Help Tuning VVE / Start and run, but not idle

    Started by Loose_Screws, 3 Days Ago
    3 Pages •
    1 2 3
    36 Attachment(s)
    • Replies: 48
    • Views: 857
    LS ROB
    15 Hours Ago Go to last post

  12. Tuning MAF and VVE at the Same Time

    Started by Cringer, 04-04-2023
    12 Pages •
    1 2 3 ... 12
    30 Attachment(s)
    • Replies: 225
    • Views: 38,032
    DobermanRacing
    17 Hours Ago Go to last post

  13. Post Bad E38 ECM?

    Started by Richard F., 1 Day Ago
    4 Attachment(s)
    • Replies: 14
    • Views: 227
    TheMechanic
    22 Hours Ago Go to last post

  14. Fuel trims sporatic randomly.

    Started by 8aHemi, 3 Days Ago
    5 Attachment(s)
    • Replies: 14
    • Views: 417
    edcmat-l1
    1 Day Ago Go to last post

  15. Camaro ls3 boost e85 wot

    Started by Chad1234hol, 5 Days Ago
    2 Attachment(s)
    • Replies: 4
    • Views: 257
    Alvin
    1 Day Ago Go to last post

  16. 2009 Escalade E38 ECM Programming Problems

    Started by jimtruett, 2 Weeks Ago
    • Replies: 3
    • Views: 242
    Alvin
    1 Day Ago Go to last post

  17. Such thing as too low idle?

    Started by dassaur, 3 Days Ago
    • Replies: 5
    • Views: 200
    Alvin
    1 Day Ago Go to last post

  18. E38 Throttle Response Adjustments - Desired Throttle Area Table

    Started by bgreen, 05-28-2020
    3 Attachment(s)
    • Replies: 19
    • Views: 5,422
    [email protected]
    1 Day Ago Go to last post

  19. Engine breaking/DFCO or off throttle timing?

    Started by MTGOAT, 4 Days Ago
    1 Attachment(s)
    • Replies: 3
    • Views: 215
    MTGOAT
    1 Day Ago Go to last post

  20. cold start almost stall

    Started by 8aHemi, 4 Weeks Ago
    10 Attachment(s)
    • Replies: 17
    • Views: 834
    8aHemi
    2 Days Ago Go to last post
Page 1 of 833 123451151101501 ... LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.