2 Attachment(s)
2018 Mustang Ecoboost NX2 Install
New to tuning in general and have taken the Tuning School Coyote class and have purchased the ecoboost course. Car is a 2018 Mustang manual.
I purchased this mustang to learn the tuning craft on. We have a drive on drive off Dynocom DC 15000 dyno at out shop also. I am NOT trying to develop tunes to sell just learning with this platform at this time. I have made a couple of tunes to this car and have it putting 325hp out now with great drivability. Currently the car has the following mods.4 BAR Map. CV Fab race intercooler and pipes, CV Fab catted downpipe and flomaster cat back and a JLT intake. 4bar MAP and IC were just put on this week and car has not been on the rollers yet with those mods. The next part to be installed is the NX2. I'm having issues understanding how to modify the turbo efficiency tables using the coefficient editor. I also don't fully understand the adjustments to the cannister pressure tables and TIP desired. Like I said I am new and picked here to start LOL. I have attached the current tune being run on the car as well as the 4bar/intercooler tune. Car has not seen the dyno with the IC and 4bar installed yet.
Feel free to roast the files...I'd rather learn now than later with parts scattered on the dyno.:worship: Thanks.