My Scanner is reading 0 on my exhaust cam angle. I thought maybe something was up with my sensor or the PCM. I went back to an old log where it read 125 and that old log is now showing 0.
Any ideas on how to address this?
Printable View
My Scanner is reading 0 on my exhaust cam angle. I thought maybe something was up with my sensor or the PCM. I went back to an old log where it read 125 and that old log is now showing 0.
Any ideas on how to address this?
with a JPEC2 controller the parameter to log is 'exhaust cam center position'
with the JPEC2a look for 'exhaust cam angle'