Seem to hit brick wall on Main Fuel

Built a tune and it runs Great, nice power increase and NO Smoke

I consider it to be a mild tune as I am concerned about fuel mileage.

During data logging I noticed the Main Fuel mm3 will not go over 79.7 mm3 and I set up the main fuel table as high as 135 mm3

I also raised the Max allowed fuel as necessary as well as torque management tables

There must be something else limiting fuel delivery but I can't find it.

Any suggestions?

I was looking around in the code out of one of our LLY's this weekend, I think I saw another fuel quantity cap in there - I'll see if I can find it again.

that is the limit of the Main Fuel Rate PID :(

i need to add it as an MPID so you can scan higher values.

So I am getting the fuel but I can't see it in the scanner, I can live with that for now :drivin:

I suspected it might be that seemed to flat lined.

Thanks for all your hard work, You Guys ROCK