Printable View
I'm trying to read my transmission on vcm editor but it doesn't let me. When I read normally and go to the transmission tab, it's blank. I'm trying to read only my transmission but I don't even have an option for that. There's no way there's no transmission options for a 2018 so what am I doing wrong? Thanks!
I suggest opening a ticket at HP Tuners ([email protected]) explaining your issue.
DodgeBoy.
YouTube: https://www.youtube.com/@dodgeboy2785
Do you have the By-pass cable installed?
Very good point N2Speed...
Link: https://www.hptuners.com/product/dod...-access-cable/
Yes I doQuote:
Originally Posted by N2speed
I've been reading and writing tunes I have itQuote:
Originally Posted by DodgeBoy_8HP
bump, just boosted the car need to tune trans and still unable to. I've been trying to contact support for the past couple of months, no response.
Can you post a screen shot of the VCM Editor when you try and read it?
I don't have my car nor mpv but I think I have a picture of that, let me check.Quote:
Originally Posted by N2speed
You have to select the hardware. What version of the software are you using
I'm pretty sure hardware was blank as well, I'm using version 5.0.4
Did you pay the credits for the trans?
Is it separate from the ecu? I bought the mpvi3 with 2 creditsQuote:
Originally Posted by james1595
Yes
I believe ZF 8HP requires four credits (normally).Quote:
Originally Posted by Gun
When you say four credits do you mean I need to buy four more credits for that itself or just two more since I already have two?Quote:
Originally Posted by DodgeBoy_8HP
So I just buy more credits and redeem them and my tcm is unlocked?
I would believe all 4 credits need to be addressed to the correct/same controller (which is ZF 8HP TCU).
Once another 2 addressed, it should work. If not, maybe get in touch with hp tuners support service.
Link: https://www.hptuners.com/vehicles/stellantis-tuning/
Look at "DODGE/CHRYSLER/JEEP/RAM TRANSMISSION CONTROLLERS" => "18-23 ZF8HP2 8-Speed Transmission Control Module (TCM) 4"