2014 Ecodiesel 3.0, no communication with ecm after update

2014 Jeep ecodiesel 3.0 auto

Connected MPVI2 and followed instructions to perform the initial update. Read the controller but HP only gave me tcm read file. Now I have no comunication with ecm at all and the dash is full of messages from "press clutch to start" to "Service Air suspension" ect.

I hope the ECM is not bricked. Ive put in a support ticket but i wanted to see if I wasteing time and I should begin looking for another ECM.

Im running latest beta software and MPVI firmware is updated.

Any help or advise would be greatly appreciated.

I'm sorry you're having troubles and we'd love to help you. Have you already opened up a support ticket where you've reported the issue? If not, please open a support ticket here: https://support.hptuners.com

Yes I submitted a support ticket earlier today. It?s number [#408294]

I just had the Same problem. 2019 ram 1500 ecodiesel "classic" using the mpvi3. Tried to read the stock tune, said I needed to update... after update can no longer communicate with ecm. How did you resolve the issue?

Either of you guys get this figured out? Or did the dealer need to reflash your Ecu's?

Have any of you figured it out yet? I am currently trying to do the update and it is sitting at 100% cleaning up and has been for an hour or more now.
2019 Ram 1500 classic slt 3.0L eco diesel.

Following in case I have the same issue, and bump for a resolution