2017 Sea doo GTI 155- Supercharged P0106 Problem
I wanted to reach out and see if there was something that could be done about a current problem I'm having. I have a 2017 sea doo GTI 155 that started life as a n/a ski. I have since converted it to supercharged with a x charger and 137 wheel. I am using HPT and have got the ski tuned where it runs and drivesappropriately, however once it gets in the upper rpm around 8400 it starts making about 190-192kpa of boost it throws a P0106 map sensor out of range code and goes to limp mode I assume. I installed a brand new map sensor after this and it does the same thing. The map sensor is a factory bosch I tried setting the disable voltage high at 12v just to see and it didn't change anything. I also tried to move the map sensor P01016 fudge factor in both directions with big swings. I am curious if since this original calibration file has a hard limit in it due to it being for a n/a engine from the factory. Is there anything else you could think of? Is it possible there is something not defined? I am using the latest software download (downloaded it last Friday night).
