Printable View
ok so I have my WB all hooked up but sometimes it wont show on the scanner when i hit rec and sometimes it does. when it does all it reads is 14.7, do I have a setting wrong? which serial channel do i use in the innovative list? also how do i make it link to the hyst for afr err?
You have to close out the scanner and open it again for it to pop up. Just something I’ve delt with for a while with mine. Are you connected to the right pigtail from the gauge?
connecting to the output pigtail, tried closing and reopening it , it pops up on the scanner but only reads 14.7 but doesnt change
so which of the innovative channels do I need to select in the scanner. status, Stoich afr , EQ ratio or AFR
Just AFR. I tried stoich afr and it did not work just stayed at14.7.Quote:
Originally Posted by Spoolnsquirrels
As for in your graph choose AFR Error (Math) from the list and place it against maf or ve and away you go. As long as you have Innovate SP - AFR in your channel list the scanner automatically uses this input as a generic AFR input for you engine parameters