Printable View
I'm looking at DFCO settings and under "DFCO Entry Spark", "Blend Time" it says that the numbers in the table are the number of crank refs that it takes for....
What is a crank ref? I assume it is a certain number of degrees of crank rotation, but how many? Or am I completely wrong?
Rob
Really wish someone could answer this, I'm struggling with the exact same problems.
Typically, 'reference' means the significant part of the pattern in the reluctor wheel that tells it where it is. It's called that and not something like 'TDC' because there's an offset between the reference notch and actual TDC (it sees the reference notch, then counts a certain number of pulses past that to find TDC).
Ahh thank you for the clarification! So is it a stupid question to ask how many crank refs there are per revolution (I'm assuming there's only 1)? I'm trying to find out exactly how long my delay for DFCO is if it's measured in crank refs.