4 Attachment(s)
[B]Scanner will not graph logged parameter (fuel pressure)[/B]
Hello! I have been trying to get my Scanner to graph my fuel pressure without any success. It is an external sensor connected to my MPVI Pro input #3. I have added the MPVI Pro #3 input to my channel lineup, and performed the correct transform (AEM 0-100psi) to get the correct psi reading. When datalogging, the log tracks fuel pressure just fine, but it will not show up on the graph.
I'm sure I have just overlooked something, but for the life of me, I can't seem to figure this out. I have posted a couple of screenshots below, as well as added my channel config and log file.
Thanks for the assist!
Attachment 111373
Attachment 111376
Attachment 111374
Attachment 111375