Hi,
Can any one point me in the right direction to change the settings in our auto ecu to allow our manual gearbox to run?
Conversion is done and starts etc, just has a limiter at 2500 rpm
I believe we need to change a few settings for vss?
Thanks
Printable View
Hi,
Can any one point me in the right direction to change the settings in our auto ecu to allow our manual gearbox to run?
Conversion is done and starts etc, just has a limiter at 2500 rpm
I believe we need to change a few settings for vss?
Thanks
post your file
Attachment 81882
see below for BA swapped from BTR4spd to glide or effectively a manual
How did you go with this, why didn't you just start with a base manual XR6T file rather than try & mod a auto file?
All went well, was not aware you could write a manual tune into an auto pcm.
ahh cool, glad it worked!
But yeah in future you can check calibration listings & make sure it's the same year/model & write entire(only option with HPT, AFAIK) for the controller & it will write the manual calibration over the existing auto calibration but leave all the other security items needed the same to work!
Trans>General
Automatic=Disable
Load Switch=2