Serial wideband(LC2) not reading correctly in scanner..

I seem to be having a little trouble with mine. I have an LC2 and I have tried two different sensors. For some reason, when I select innovate AFR, it gives me values 300 to over 1000 instead of the standard values(14.7 ect). Any idea whats going on, or what I am doing wrong? -Mark


You'll notice how it stays at 20.9 for the first minute or so. That's when I have the sensor in free air. As soon as I put it in the tailpipe, it goes crazy.

Also, it reads correctly through the Logworks software, so I know the sensor is functioning properly.

Quote:

---

Originally Posted by Snyper

I seem to be having a little trouble with mine. I have an LC2 and I have tried two different sensors. For some reason, when I select innovate AFR, it gives me values 300 to over 1000 instead of the standard values(14.7 ect). Any idea whats going on, or what I am doing wrong? -Mark


You'll notice how it stays at 20.9 for the first minute or so. That's when I have the sensor in free air. As soon as I put it in the tailpipe, it goes crazy.

Also, it reads correctly through the Logworks software, so I know the sensor is functioning properly.

---

Feature is still under development. Will keep you and the community up to speed on its progress.

Thank You for your patience,

Ed M

Can I still use the old method?