2 Attachment(s)
VCM Set-up for AEM wideband
Amid all my tries I cant seem to figure out how to set-up my AEM x-series OBD II.
I was able to set-it up to read the wideband but I'm looking to see if anybody knows how to set it up to read % of fuel correction in the VCM scanner.
Hopefully if it can then I can go into my Virtual vve and multiply by % and adjust manually as needed.
I have the mpvi2 and vcm suite 4
Attached is a VCM layout file and test run file
If you look at the graphs I can get the afr error to move around in the cells but it isn't logging anything.
Any help would be greatly appreciated.
Lastly I did try to set it up according to the thread "HOW TO: Setup AFR / Lambda ERROR Graphs vs. VE Table (non Virtual VE Vehicles)"
It didn't work