-
JK Stuck in 1st on Dyno
Searched a bit and found others who had similar issues but didn't seen any real resolution except for some general advice that has worked on other platforms.
Had a 2010 JK, supercharged, on the dyno and with it in 2wd it was throwing a fit and only allowing autostick in 1st gear, no response to hitting the shifter trying to move up gears.
What have you guys done to get these things into higher gears?
-
I just had a 2012 JK on my dyno. I found if the tires are rolling it won't shift. However if you put it in gear and hold your foot on the brake tires not turning yet you can manually shift into 2nd or 3rd gear. Once the dash says 2nd gear once you start rolling it will shift into 2nd and hold that gear for the pull. Same might be true for 3rd but I did not try to use 3rd gear.
start truck
hold brake
pull shifter into drive then to the left to enter manual mode
push right to show 2nd or 3rd
release brake and start the pull.
-
for the jks make sure u disable the traction fully ( remove fuse or VSM editor) before dyno run other wise the stick shift will not work / i always pull the run whit the third gear
-