Printable View
I have added a parameter to all of the currently supported V6 and V8 Mustangs (2005-2010). It is in 2.24. Build 515
Attachment 43292
The fact that we were missing this was brought to my attention over the weekend. Not sure how I overlooked it myself! Doh!
Set this value to zero to permanently disable the traction control system. Vehicles with the interior upgrade package will get a few errors on the dash due to the way this eliminates the traction control. This is normal.
thank you! so many people have asked because they are tired of pushing the button!
If you find something is missing, please don't hesitate to email support. These types of issues are #1 priority.
Does that parameter exist in the Aus ford Builds Eric?
It may, I have not looked. Do you have a traction control button?Quote:
Originally Posted by hiddeous
Sure do!
I'll check tomorrow and if it is there, I'll enable.Quote:
Originally Posted by hiddeous
Champ!
2.24.518 and above has the traction control scalar added to all Mustangs, and Aussie vehicles we support. :-)
Like!
On my 2009 FGt I tried the values 0,10,20,30 and it did not work. Just threw the ZF6sp into spaz mode stuck in first gear with trans error comming onto dash.
Put back to 40 which is factory setting and back to normal.
I tested this solution:
Works without setting lamps on dash.Quote:
Originally Posted by BlueStreak
tried that, does not work on my fg falcon. thanks nevertheless
I'm looking at other ways to disable it. This method works on the US vehicles, but being that those cars come with a separate TCM , there may be some additional changes that have to be made. I will investigate.Quote:
Originally Posted by turbotrana
Any updates on disabling TC without dash lights?
I don't have a "etc torque reduction vs rpm" table. Maybe it got renamed since then.
Maybe setting this to zero:
[ECM] 44814 - Desired Air Mass Multiplier (Traction Control): Amount of Desired Air Mass for use in traction control.
After more reading, I tried setting [ECM] 44814 - Desired Air Mass Multiplier (Traction Control) to 100% not 0%, but TC still definitely kicks in and closes the throttle.
Setting "traction control disable" to 0, does effectively disable TC and SC. But it leaves you with an annoying flashing ABS light (despite ABS still working).
Any way we can disable that light? I scanned the DTC settings and don't see anything likely there.
SCT has a parameter that you can ask support for but to be honest, I never messed with it so I'm not sure it will do what you want.
Attachment 91621
Quote:
Originally Posted by Witt
Thanks Witt!
I flashed my car with it running...yes dumb mistake.....My ABS and Traction control lights are on and there isn't any DTC. Abs doesn't seem to be working.....any Ideas??? NOVICE just started to lean how to tune. Was shocked at what I was told from a shop so bought my HP tuner....any help is appreciated....Many upgrades on motor