Printable View
Most time when turn the key to the on position I see a Actual Torque value of 1142. This is the same as Driver Demand Torque 1142
The car is cold key on engine off
Hellcrate motor, headers, CAI
The file I included is after a long idle
Codes are P0171, p0174, p2174, U1110
Attachment 89258
What causes the value of Actual Torque to be high at key on engine off?
Is it running on the tune that came on the PCM? I just finished a swap and could look through some stuff later.
Yes completely un tuned. Would you send me stock tune (un modified) and or I can send you mine. I?d like to compare. They should be exactly the same. Can I see a running log too please?
Sounds normal to me, if the engine is not running, VCM scanner will report a high actual torque value. In fact, on my challenger if you look at the engine torque display with the engine on but not running it reports 412ft-lb.
I can get you some stuff and I will take a look at this log later. I completely forgot. Also, I actually screwed up and copied over my stock read. I have one that had some very small changes saved, so if I could get a copy of yours, I could correct mine and see if there are any other major differences that I can see.
Attachment 89360Quote:
Originally Posted by unicornpower
No worries, here is the factory Hellcrate Tune un touched.
Yeah. A lot vehicles will show strange values with KOEO.Quote:
Originally Posted by Homer
OP is there an actual problem or were you wondering why it was showing that?