Map calibration, missing parameters in tune to add 3 Bar MAP?

I'm working on an 16' F150 5.0 engine that was swapped into a 1970 F100 and has a supercharger strapped to it. Most tunes I look at have MAP and underneath it has Characteristics where you can adjust the MAP Slope and MAP Offset. The Tune from this truck does not but has TIP Characteristics with Slope and Offset adjustable there. Is this mislabeled or am I missing parameters I should have to be able to scale a 3 Bar MAP sensor?

Attachment 101039

Quote:

---

Originally Posted by mechanicboy

I'm working on an 16' F150 5.0 engine that was swapped into a 1970 F100 and has a supercharger strapped to it. Most tunes I look at have MAP and underneath it has Characteristics where you can adjust the MAP Slope and MAP Offset. The Tune from this truck does not but has TIP Characteristics with Slope and Offset adjustable there. Is this mislabeled or am I missing parameters I should have to be able to adjust to add a 3 Bar MAP sensor?

Attachment 101039

---

Not sure what you are looking for but MAP sensor SLOPE and OFFSET are present in your tune. TIP is disabled, ignore it won't work.
Attachment 101041

What the heck. What version of VCM are you using? I'm using Beta Version 4.5.1346

Attachment 101042

Well I figured it out.

I'm used to it auto updating when I'd go from Help > About and it would notify me of updates. It's been months since it updated and I assumed it was because of COVID. I manually downloaded the latest beta and it's all there.