proper way to rescale injectors on Caliber SRT4 GPEC pcm

anyone have any advice on how to go about this the proper way? Every time i attempt to put the real flowrate into the injector flowrate table, "stock its at 62.44", it actually leans everything out to where im not sitting at stoich during idle or cruising. new injectors are 74.50 at 43.5 psi. i have read and done research on mopar injector scaling but im still lost... any help would be much appreciated. 08 caliber srt4 gpec pcm. theres not many of these cars out there so it seems almost impossible to get much help.

Have you tried any other values for change? 68.60?

Quote:

---

Originally Posted by * _ *

Have you tried any other values for change? 68.60?

---

Yes I have. It seems that it's based off of calculations from the map, ect. Hp tuners never even mapped out the table for injector duty cycle, or even knock.. Its pretty sad.. Nothing like gm vehicles

Caliber runs a 5 Bar fuel pressure at stock! I put deka 80's in there and my number in the box is 105.05 Doing just fine.