Printable View
for the last week to read from a 2004 dodge dakota 3.7 (ngc3) i have tried it both in the vehicle and on the bench with no luck. when i read from the ECM i get a timeout failure and when i read from the TCM it saves the file but will not open it. attached are screenshots of the errors i am getting. i have allredy contacted customer support and they have not been able to resolve the issue yet. i am not concerned about the TCM but i really need acess the ECM.Attachment 88705Attachment 88706
Any update of this? I have a similar issue with a 2004 Ram. Doing the same thing
That is odd. I have a 2009 Dodge with a NGC4 and it reads fine after I realized it could only read it with key on engine off lol. Hope HPTuners is eventually able to help but I personally have no ideas
Old post, I know. But...
Some of the NGC3s are not supported. Are you sure yours is?
When I switched to a NGC4 I still had trouble reading. But I found that disconnecting the TCM while reading and writing did the trick.
Have you tried selecting the TCM in the second dropdown?
hi friends
is possible read this NGC3 on bench ? i have same trouble hptuner not recognise my ngc3 from 300C year 2005
thanks ;)
That will only work if your NGC3 is supported.
Some of the NGC3s are not supported. And it sounds like yours isn't.
thank for your helpQuote:
Originally Posted by gottogo
so i must test with ktag opening this ecu
anybody have experience to open ngc3 ?
Sorry, never could get mine to read.
Yes you can read these ecm's via bench harness, its the primary way we do our reads(via bench harness).
Hey bill so all ngc3 can be read by bench and are supported? I still can’t get my ngc3 for my 2004 ram to read the ecm. The trans reads fine. I’m think about swapping to an 05 computer now. Reason for this is the build date