AEM 30-0334 Boost Analog Logging, Need Help Converting the Volts to PSI w/MPVI

Its been years and I'm rusty,
I connected the + & - wires from the AEM 30-0334 boost gauge to the MPVI enhanced I/O and my gauge is reading in volts, not PSI and googling and pecking around has not bared fruit for me.
I went through this back in 2005 but need the next steps from this point again.

Any help or links will be much appreciated.

That model gauge is a wideband controller not a boost gauge.
You also need to provide enough information. What version of the scanner are you using?

How Embarrassing,
Its the AEM 30-0306 X-Series Boost Gauge.

I'm using scanner version 4.4.2. Thanks.

I'm trying, pecking away at it but cannot get it to show up. I need step by step I guess.

2013 Charger R/T 57L Edelbrock E-Force supercharger.
I have their MAP sensor utilized and the white and brown wires terminated as instructed going to the Enhanced I/O plug on the interface.

I google my behind off but cannot get the level of help I need.

Thanks

Quote:

---

Originally Posted by 2therock

I'm trying...cannot get the level of help I need.

Thanks

---

Quote:

---

Originally Posted by 2therock

Thanks, I wish someone would see my Boost 30-0306 thread and help me configure it. Its kicking my rear.

---

i came here from the other thread, and found nothing here either. What did you end up doing? Im hoping you got it figured out in 3 years time span??