VCM Set-up for AEM wideband

Amid all my tries I cant seem to figure out how to set-up my AEM x-series OBD II.

I was able to set-it up to read the wideband but I'm looking to see if anybody knows how to set it up to read % of fuel correction in the VCM scanner.
Hopefully if it can then I can go into my Virtual vve and multiply by % and adjust manually as needed.

I have the mpvi2 and vcm suite 4
Attached is a VCM layout file and test run file

If you look at the graphs I can get the afr error to move around in the cells but it isn't logging anything.

Any help would be greatly appreciated.

Lastly I did try to set it up according to the thread "HOW TO: Setup AFR / Lambda ERROR Graphs vs. VE Table (non Virtual VE Vehicles)"

It didn't work

if u use the maths error and then fit a WB on a different input u then just have to change the input on the maths error to suit and it should work as normal

It took some time to figure it out but I got it.

If anyone wants to know how let me know.

Joe please post how to do this as I can't get it to work right

Any updates to this Joe?

I got it to work but I'm not sure if it's correct for logging my EQ Err vs VVE..?

My graph has RPM on the X axis and Pressure Ratio on the Y axis to give me the EQ error %.

Joe53016 can you post how you did it so us newbs can see how you did it? Thanks man.

X2 please?

Bump for X3

Bump cause was easy once I realized I had to re-sync my MVPI2 in the VCM scanner program since I upgraded to Pro. Was doing everything right except for that.